I've noticed the same problem. I think it may happen when you build up static electricity and then release it through your finger. That's my only thought because I just put a fresh Duracell battery in and I know that it should work after that and I just shocked myself a bunch of times today and noticed that the watch had been reset.
To turn off the alarm you hold down 'Reset' and press 'Start' Hope this helps!
To change the day on the AW60443W WR100ft watch, pull the crown out to the first position. Turn the crown clockwise to set the day to the desired value. Once the day is set, push the crown back in to its original position to complete the adjustment. Make sure to avoid changing the date or day when the watch is between 9 PM and 3 AM to prevent damage to the mechanism.
On the backside of the watch, there is a reset button hole with the words "reset" next to it. *you'll need a pin to press the button.
Once you have repaired the cause of the light, it will reset itself.Once you have repaired the cause of the light, it will reset itself.
To reset a Shark watch, first locate the reset button, usually found on the side of the watch. Use a small tool like a paperclip to press and hold the reset button for a few seconds until the watch resets. If your model has a specific reset procedure in its manual, refer to that for detailed instructions. After resetting, you may need to set the time and other functions again.
drive it. It will reset itself
To reset a Cardinal WR50M watch, first, pull the crown out to the second position. Then, press the reset button, usually located on the side of the watch, to reset the time or features. After making your adjustments, push the crown back in to set it in place. Make sure to check the watch's manual for specific instructions related to your model.
It will reset itself while driving if pressure in spec and sensor itself is not bad
Are you serious?
It will automatically reset itself after you have started the car 50 times after the problem was fixed, or sometimes if you disconnect the battery for a while it will reset itself.
To reset a marathon watch, locate the reset button, often found on the side or back of the watch. Press and hold the button until the display resets to its default settings. If your watch has multiple functions, you may need to navigate through the menu using additional buttons to reset specific features or modes. Always refer to the user manual for your specific model for detailed instructions.
I think you are supposed to plug it into your computer with itunes, and it should reset itself.