how do you hook up an outlet to a pull chain light without the outlet shutting off when you pull string
Not if the GFCI breaker is supplying the circuit you are wanting to put the GFCI receptacle into.
Do you need to find the outlet at a hardware store, electrical store or around your pool area? At your pool area - GFCI's can sometimes be found around the pool equipment pad. Sometimes they are located just off the deep end of the pool at the edge of the deck straight back from the pool light if your pool has a light. However these fixtures do not have any access to an outlet. It is usually just a GFCI fixture. GFCI's can sometimes be found in shrubbery surrounding the pool. You just have to hunt for it in those locations. And there are the instances where no GFCI is provided. There may also be a GFCI in the circuit breaker box but this one will not have an outlet. What is your need for an outlet? If you have a pool light that does not have a GFCI in the system you then need to call a qualified swimming pool electrician or a qualified pool tech to install one. There are special requirements for this application.K
Your question sounds simple but it isn't. There are two ways of wiring a light to a switch. One is to bring the hot and neutral wire to the switch box and from there run wires from the switch to the light. If this is the case you can install a GFCI on the circuit. The other way is to bring the hot and neutral wire to the light and from there run two wires to the switch and switch the light that way. In this case you cannot install a GFCI to in the switch box. <<>> The way you want the circuit to work has to be laid out as follows. Method one, the circuit that now controls the bathroom devices can be changed to a GFCI breaker. This is probably the quickest and cheapest, unless the job is new construction. Method two, if new construction use this method, as tearing walls open to get to the wiring will become costly. Where a supply circuit comes from the service distribution panel the first device on that circuit has to be a GFCI receptacle. This device has secondary terminals on it, that if connected every device downstream from it will also be protected. So if you supply the two way light switch that controls the vent fan and a bathroom light from the secondary terminals from the GFCI receptacle they will be protected.
A GFCI outlet has a TEST and RESET switch. Press reset and see if it fixes problem. If reset won't stay in that means that a ground fault condition is present and may be on another outlet that is fed from the tripped GFCI. If this isn't the problem check the main breaker feeding the GFCI and ensure it isn't tripped. If none of this works the GFCI itself may be bad. If you have a Volt Meter you can remove the outlet from the wall receptacle and make sure there is voltage present. You can also see if there is a branch circuit connected. To troubleshoot you can disconnect the branch circuit and then try reset. If you have voltage on input and GFCI won't reset with branch circuits removed, replace the GFCI.
Why will my Motorola bluetooth HS850 LED light not stay lit long enough to set up to my phone?
The parking brake light stay lit on the 1999 Mitsubishi Montero sport the parking brake is working and you have not put the light off.
Nothing
66
89 days
yes I can get the pilot to stay lit
66
66
66
66
66
66