answersLogoWhite

0

Why does the Isuzu rust in the rearend?

Updated: 8/17/2019
User Avatar

Wiki User

14y ago

Best Answer

indeed, the water gets trapped in the bumber.

User Avatar

Wiki User

14y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: Why does the Isuzu rust in the rearend?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

How do you increase tow capacity?

Get a heavier duty rearend. the tow capacity is based on the rearend. Chevy 10, 12, and 14 bolt rearend.


What kind of rearend came in the 1969 impala?

In 69 you could get whatever you wanted, a lot of impalas had the 12 bolt rearend and some had the 8.5 10 bolt rearend.


What kind of rearend does a stock 96 ford bronco have?

what kind of rearend does a stock 96 ford bronco eddie bauer have.


Will a 06 rearmed fit an 05?

Rearend


Who makes the Dana rearend?

Dana i believe


How do you remove ans Axle from a 2000 camaro?

take all the bolts out of the rearend pumpkin cover and you will see the rearend gears, push the axle inwards and you will see a C clip that holds it in place inside the rearend, pull the C clip out and then you can pull the axle out.


Where are the brakes on a mtd yard machine?

The brake is on the rearend. Depending on what year the mower is will tell you which side of the rearend it is on. More recent mower will have it on the right side of the mower. You should be able to look under the mower just in front of the right rear wheel and see the rod going from the linkage to the rearend. It goes through a lever on the rearend. There is a nut where that pivots. If you tighten that nut it will adjust the brake.


What size rearend is in a 2000 Chevrolet Z71?

8.6


Does a 1988 4.3 s10 blazer have a posi rearend?

no


What rearend came in a 1989 mustang gt?

8.8


What gear ratio is a nissan HF37 rearend?

3.73


How do you replace the axles on a 1969 GTO?

the backing plate on the rearend has to come off and there are C -clips that you have to pull out of each axle where they mesh with the gears inside the rearend and then you can pull the axles out.