0
What else can I help you with?
Why does only the HIGH blower work on my 1997 Nissan maxima?
Your blower switch sensor is out. Replace it!Then all the speeds will work
Heater blower on 1997 safari will not work on high?
Sounds like your dial/switch controal is shot or faulty. Try and replace that than see what happens. Just happened to me recently with the temp controal dial.
Where is the heater relay switch in 1997 Chevy blazer?
The high speed relay for the blower motor would be found under the hood, on the passenger side of the firewall, close to the blower motor speed resistor.
1970 Chevrolet high speed blower switch not working?
replace the switch.
Blower motor only runs on high?
Bad resistor at the blower motor? Bad blower motor switch?
Why does the acheater blower only work on high speed?
either the blower control switch or the blower motoer needs replacing
On a 300m the blower is stuck on high and can not be controlled with the switch is there a sensor for the blower to control it?
There is a Blower Motor Resistor Pack. Either the blower motor speed control switch itself is defective or the Resistor Pack is bad.
El Camino blower high speed fuse location?
if your blower is working on low and medium speed then it's not a fuse it is the blower switch
Why Small omount of a-c air coming out of vents with switch on high on a 96 cheve 7.4 truck?
Could be,The blower speed switch or electrical plug at switch is burned out. The high speed blower relay is burned out. The blower motor is on its way out. The blower motor speed control resister is burned out, The cabin filter (if applicable) is very dirty.
1985 gmc Suburban blower does not work on high what can it be we changed blower resisitor and silver circut breaker near blower and blower itself?
switch contact"s
Why does the Ac blower stop on my 1997 Chevy s10?
There is a replaceable resistor which is in the engine compartment located on the blower. It is usually fastened by two small screws. Remove the electrical connectors and get a replacement. If the resistor is burned out you will still have high speed. If you have the lower speeds but no high speed, replace the blower motor high speed relay. If you have no speeds at all I would suspect either the blower speed switch and its electrical plug is at fault or the blower motor itself is bad.
Blower switch only works on low high 2000 Camry?
either the switch or the fan motor
