0
Normally the brakes start making a noise when the brake pads are worn past a certain point. A wire pops out and they start making a noise. That means the pads are thin and need to be replaced. Since you ignored that noise and waited until they started squeaking, it means you let them get to the point where they wore down to the rivets. They squeak because metal is scratching on metal. Now you have to replace the whole unit and not just the pads. You have an expensive repair job ahead.
Wiki User
∙ 14y ago
Add your answer:
Earn +20 pts
1994 Chrysler LHS died on the road and now does not want to start why?
how do you install a crankshaft sensor on a 94 Chrysler lhs....where is it located on a 94 Chrysler lhs???????????????????loisanne0@hotmail.com
Does a 94 Chrysler lhs have a factory alarm?
It was as factory option.
What kind of variable effort steering is the 94 lhs Chrysler?
The Chrysler LHS comes standard with a speed proportional rack and pinion power steering assembly.
Is there a fuel shut off switch for a 94 Chrysler LHS If so where is it located?
Chrysler does not have shut off switches.
Where is the heater core located in a 94 Chrysler LHS?
You have to remove the upper headers and it should be there toward the radiator and the fuel rail
Is there an impact shut off fuel reset button on a 94 lhs?
No.
Why 94 lhs engine shakes when accelarating?
sounds like you have a bad motor mount
What would cause a 94 Chrysler LHS to run hot it's not the thermostat?
This question is not complete. . Need to know if you've replaced radiator, thermostat, hoses etc. Are you asking this question *after* yo checked the thermostat, changed, added or drained the system?
Does the valves bend on a 94 2.2 sundance engine when the timing belt breaks?
AnswerThe Chrysler 2.2L and 2.5L 4cyl. engines produced from 1981-1995 are non-interference so if the timing belt breaks the engine will simply stop with no damage to engine parts.
Odb diagnostic connector outlet located on the 94 Chrysler 300?
There was no 1994 Chrysler 300.
94 lhs won't start getting no spark you'll change the core pack what can you look for?
i had same problem on my 94 changed the crank and cam sensor then it was fine
What is the DC Amps for a 2001 intrepid alternator?
Nippondenso ER/IF 120 Amp, 12 Volt, CW, 6-Groove Pulley Used On (2001-98) Chrysler Concorde 2.7L(2001-98) Dodge Intrepid 2.7L Mitsubishi ER/IF 130 Amp, 12 Volt, CW, 6-Groove Pulley Used On (2001-99) Chrysler 300, LHS 3.5L(2001-98) Chrysler Concorde 3.2L(2001-98) Dodge Intrepid 3.2L(2001-00) Dodge Intrepid 3.5L Nippondenso ER/IF 90 Amp, 12 Volt, CW, 6-Groove Pulley Used On (1996-93) Chrysler Concorde 3.3L(1997-93) Chrysler Concorde, LHS 3.5L(1996-94) Chrysler New Yorker 3.5L(1997-93) Dodge Intrepid 3.3L, 3.5L(1997-93) Eagle Vision 3.3L, 3.5L(1997) Plymouth Prowler
