answersLogoWhite

0

The key needs to be coded to the new barrel, or swap the immobalizer ring from the old barrel to the new one(if using the old keys)

User Avatar

Wiki User

15y ago

What else can I help you with?

Related Questions

How do you reset the change oil soon light after you have changed the oil in a 1999 Gmc Sierra?

Turn your ingnition switch on and pump the gas pedal 3 times. Then turn off your ingnition switch wait about 3 seconds then go ahead and start it.


Why won't my ford falcon 1999 Au not turn over or fire to start after the ignition barrel was changed?

The barrel is not timed properly to the switch.


How do you hot wire your ski doo?

pop the hood, rip out the ingnition start and swing the pull start


What does ingnition switch mean?

ignite or start a car,truck,boat or plane


For 2002 Mercedes s430 i put the inside ingnition key but i can't turn it on?

i have 2002 Mercedes s430, i put the key inside ingnition but i can't turn the key to start the engine, can you tell me what is the problems?


Can a Opel Corsa start without the on board computer box?

NO


Why won't your Vauxhall corsa start?

check out youtube/ scotty kilmore why car wont start


How do you start a double barrel?

There is no need to start a double barrel. A double barrel shotgun needs to be loaded like you would a single barrel shotgun only using two bullets. You then cock the gun, aim, and fire.


What if your 1996 1.2 corsa wont start in the morning but once you get it jump started it works all day but you changed battery and plugs and distributor cap unsure what else can be?

check for a draw...(PULLING 12V W/ KEY-OFF)


Your 1987 Mazda rx-7 wont even start only way it will start is if you push start it Ingnition works fine same with alternator How can you fix it you already check for vacuum leaks?

sounds like... starter.


Opel Corsa cut out while driving do not start?

Coil pack needs to be replaced


Your 1991 Olds Toronado will start and immediately shutt off what could it be?

the VATS chip wiring on the back of the ingnition switch is bad, can be bypassed by a decent mechanic