0
because it losen the blade if it was the other way.
Wiki User
∙ 12y ago
Wiki User
∙ 10y agoIt will not cut properly the other way.
Add your answer:
Earn +20 pts
Why does the coping saw blade have to face the correct position?
So that it will cut on the downstroke.
What are the pins for on a coping saw?
To hold the blade and tension it..
Which saw has a thin blade and a D shaped frame?
Hack saw, coping saw.
How can internal shapes be cut by a coping saw?
first you push the coping saw on the table by the handle until the blade pops out then, put the blade through a hole then put the blade back together then tighten the retaining pins then tighten the handle and then your ready to saw away.
What are facts about a coping saw?
We use the coping saw as a hand saw, so it is pretty easy to control the saw. If you use the coping saw, you can feel that the coping saw is very easy to control,the saw can basically cut any shapes. Some machines are very hard to cut curves with on plastic, but not this one because the coping saw just follows where you go, you are controlling the angle of the blade of the coping saw.
How do you change a blade on a coping saw?
Unscrew the handle to relive the tension on the saw. Remove the old blade, hook the new blade over the pins on the saw and tighten the handle back up.
How do you avoid braeking a coping saw blade?
It's really quite easy to break a coping saw accidentaly by putting too much pressure on the blade or moving it the wrong way. Luckily, blades are cheap.
What are the four parts to a coping saw?
The frame, handle, blade and adjuster screw.
How thick is a coping saw blade?
It is approximately 1/32 inch thick.
What is dangerous about a coping saw?
The blade is the most dangerous part of the saw so don't put your hand near it!!!
What is a coping saw made of?
the handle is usually made out of wood , the blade and frame are both made out of metal.
What is a coping saw made out of?
the handle is usually made out of wood , the blade and frame are both made out of metal.
