Most likely a bad bulb, corroded socket or worn/shorted wires. Could be the brake switch too. I'd check in that order. If it ends up being a blown bulb, see sources and related links below for bulb information.
The fuse protects the house wiring from faults. If the fuse blows it is because there is a serious electrical fault on the circuit that the fuse is protecting. You need to get your wiring/appliances checked out by a qualified electrician.
This is the starter fuse I am talking about. It doesn't blow every time. It might go weeks before it blows again.
The device that the fuse is protecting is causing the fuse to blow. It could be in the conductors that feed the device. Disconnect the device and see if the fuse blows. If it doesn't, then the wiring to the device is good. If the device is a motor load it could be seized bearing that cause the problem. With the rotor stalled the current will go high and blow the fuse. If you know an electrician, see if the device can be meggered to see if the internal wiring has gone to ground and is short circuiting as this will also cause a fuse to blow.
Slow, 1/4" glass fuse. Long obsolete. Replaced by Bussmann MDL fuses.
Mine blew too, i dont know why, i tuched some wires with my 02 sensor, basicaly exposed wires will cause ur ecu fuse to blow, i dont know why tho, i have the same problem Mine blew too, i dont know why, i tuched some wires with my 02 sensor, basicaly exposed wires will cause ur ecu fuse to blow, i dont know why tho, i have the same problem
Tail light fuse is blown. It also feeds the 5 amp dash light fuse. Also check for shorts causing the fuse to blow including the license plate light.
There must be a short in the system somewhere that causes the fuse to blow.
Unplug the ECC fuse. If the fuse does not blow, then hook up the ECC. If the fuse blows then the ECC will need to be replaced.
Sometimes fuses in cars blow out and need to be replaced. The lighter fuse is located in the fuse box, usually marked accessory.
no A FRN fuse is a slow blow fuse where an non is a fast blow fuse. In a pinch a slow blow fuse can be use in a fast blow circuit but not the other way around.
Because then it wouldn't 'blow' at the prescribed amperage. -A fuse is made with very fine tolerance wire to melt at an EXACT amperage.
If replacing the main fuse does not make the repair, it is likely another fuse is also blown. Sometimes fuses will blow all along a circuit.
Blow My Fuse was created on 1988-09-19.
Worn or frayed wire to starter?
If the fuse is labelled F it is fast-blow or T OR S it is slow-blow, the letter should be on the metal cap on the ends of the fuse.
Fuse is blown.
It did on mine. When I went to check the pump, the fuse was blown. Replaced it and found that the pump was also bad.
if it is an after market deck you must have the dash wires not hooked up behind the deck, and for the fuse replace it....