Posible relay problem
How to drill out ignition switch on 1985 ford f150?
The actual problem is the starter continues to turn after key is turned off and pulled out of ignition.
We are replacing the ignition switch on a 1976 ford F150 Need some help - give us directions
no. Make sure wiper is in "OFF" position before you turn off your car.
To replace the ignition switch on a 1993 Ford F150, first disconnect the negative battery cable to prevent any electrical issues. Remove the steering column cover by unscrewing the screws, then locate the ignition switch, which is usually mounted on the steering column. Disconnect the wiring harness from the old switch, unbolt it, and install the new ignition switch in the reverse order, ensuring everything is securely reconnected before reassembling the column and reconnecting the battery. Finally, test the new switch to ensure it functions properly.
Ignition relay is probably shot. It is in the power distribution block in the motor comprtment.
The ignition switch is usually mounted to the steering column and is operated by a linkage rod. NOTEOn column-mounted ignition switches, don't confuse the switch with the lock cylinder and keys. The ignition switch is not normally visible. On some vehicles, the steering column support has to be removed and the column lowered to find the ignition switch. On others, the switch is accessible under the dash.The ignition switch is operated by the key switch. Courtesy of Ford Motor Company. To replace the switch: * Remove the ignition switch wiring harness. * Unbolt it from its position. * Bolt the new switch into position. * Attach the witing harness.
The ignition switch is usually mounted to the steering column and is operated by a linkage rod. NOTE On column-mounted ignition switches, don't confuse the switch with the lock cylinder and keys. The ignition switch is not normally visible. On some vehicles, the steering column support has to be removed and the column lowered to find the ignition switch. On others, the switch is accessible under the dash.The ignition switch is operated by the key switch. Courtesy of Ford Motor Company. To replace the switch: * Remove the ignition switch wiring harness. * Unbolt it from its position. * Bolt the new switch into position. * Attach the witing harness.
selonoid is bad on fire wall or switch wire on stater selonoid is bad
I just purchase a f150 that needs a new ignition switch and the man at auto zone gave me directions with pictures and diagrams, I hope this is of some use. Good Luck!
TAKE A ALLEN KEY SMALL ONE AND RIGHT UNDER THE SWITCH IS A HOLE PUT IT IN THERE AND TURN THE KEY TO START POSITION AND PUSH THE PIN WIGGEL THE IGNITION SWITCH AROND IT WILL COME OUT
To hookup the solenoid switch on F150 pick-up 5.0 after replacing it, first connect a voltmeter or test light to the solenoid's S terminal. Make sure the starter receives voltage at that terminal when the ignition switch is in the on position.