the blower resistor controls the fan speeds
Radiation.Conduction and convection both involve a material medium.
There is only one condenser. That would be an air condenser.
Heat transfer will only occur if there is a difference in temperatures. So if an object is high temperature but the surrounding area is also high temperature there will be no heat transfer.
there is no medium for conduction or convection. all energy must be received from radiative sources.
because, RADIATION occurs only in vaccum.. It does not require a medium to travel... where as conduction and convection require medium to travel. CONDUCTION: heat transfer between homogenous molecules(i.e.) flow of heat inside a body from one point to another. CONVECTION: heat transfer between two mediums(i.e) flow of heat from a metal to air surrounding the metal.
Assuming that by "high," "low," and "medium" you are referring to HVAC blower fan speed and that this happens with heat as well as with AC: Replace the blower resistor. It's no good.
a bad blower motor resistor heat normally used on medium and high medium usually burns out those speeds first till only high is left normally located right back under glove box on heater box/core line usually 20-40$
If you are referring to the blower motor only working on the high speed setting, then the problem is the blower motor Resistor Pack is defective. Replace it. It can be the blower motor speed control switch but not likely.
When the fan is on high it does not run through the blower motor resistor. The low speeds don't work because the blower motor resistor is bad.
You most likely have a bad blower motor resister.......
Figured it out...the blend door actuator was not fully seated when I replaced it.
the resistor for the blower motor is busted blower works on high with out it
Most likely the Blower Motor Resistor.
Blower motor speed resistor is partially burned out.
Blower motor resistor...around $25 on eBay
There is a resistor near the blower that is bad, known cause is high speed only.
your blower motor resistor is most likely failing. sometimes that's an indication of a failing blower motor, but typically, it's a resistor module failure