replace heater relay and or heater blower motor
Bulb not installed correctly, broken wire, blown fuse, switch,
If the passenger side works but the driver side doesn't, the linkage under the arm is broken.
There are multiple reasons why the passenger heater on a 2007 Chrysler Pacifica may not work. it could be a heater coil, a fuse, or the blower. A mechanic can help figure out the specific reason.
Check the Blower resistor behind the passenger glove box. I had to replace mine this winter.
The same size that was in there is what will work with out major modifications.
The heat is transfered from the front vents and does not work when the defrost mode is on. www.trailvoy.com
If the heat in your 1990 Chrysler New Yorker is not working, it could be due to a faulty thermostat, a clogged heater core, or a malfunctioning blower motor. You may need to have these components checked and repaired or replaced by a mechanic to restore the heat function in your car.
If the bulbs and fuse are good, replace the turn signal Flasher Relay.
I have a 2005 Pacifica, I would assume these are in the same place. Look behind the engine at the "fire wall" on the passenger side. There should be a black rubber tube, about a 1/2 inch in diameter coming through the wall. It is toward the bottom. Mine was stopped up and water was trickling into the passenger floorboard. I took a small wire and was able to unclog it. Also, if you have some tubing and an air hose, that might work too. With engine cool, I was able to reach it with my hand. Hope this helps.
80.000 people work in the chrysler building
just checking why heat in front don't work and heat in back dose 2003 Mazda mpv
One or more tire pressures are not correct, or a tire pressure sensor has failed. The above didn't work for me either. I was able to remove the message by rotating my tires. I tried deflating and reinflating, retraining my tire sensors, and nothing worked. Dealerships tried selling me new sensors $$$$$$. Try rotating, it worked on my 2004 Pacifica.