If the passenger side works but the driver side doesn't, the linkage under the arm is broken.
To replace the rear wiper blade on a Chrysler Pacifica, you must first remove the old blade. You can remove it by pushing the small blade that holds the wiper in place up, and push the blade back. Once the blade is free from the hook remove it. Put the new blade in position so the hook is in position to go over the wiper attachment. Clip it into position and you are done.
The Chrysler Pacifica has U-Hook wiper blade arm attachments. See video below for Hook-End arms. Essentially there's a tab or button where the wiper blade is inserted into the hook. Press the tab/button and pull wiper out of hook. Sometimes you may have to rotate and flex the blade to make enough clearance. Lastly, your new replacements should have these same instructions on the packaging.
The Chrysler Pacifica has the most common hook-end wiper arms. See sources and related links below for installation videos. Also, purchase the replacement blades first and there will be additional instructions/illustrations on the replacement packages. Locate and press the tab or button where the wiper blade is inserted into the hook of the wiper arm and pull wiper blade out of hook. You may have to rotate and flex the blade to make enough clearance for the hook to pass through.
The 2006 Chrysler Pacifica has the most common hook-end wiper arms. See sources and related links below for installation videos. Also, purchase the replacement blades first and there will be additional instructions/illustrations on the replacement packages. Locate and press the tab or button where the wiper blade is inserted into the hook of the wiper arm and pull wiper blade out of hook. You may have to rotate and flex the blade to make enough clearance for the hook to pass through.
The rear wiper blade on a 2004 Chrysler Pacifica installs similiarly to the front wipers. See related link below for installation videos. The rear arm is either a hook-end or side lock pin. Its very easy once you see it done. Make sure you get the correct rear wiper by looking up part numbers by make, model and year.
The wiper motor should be located on the driver side under the cowl grill below the wiper blade good luck
The 2007 Chrysler Pacifica has the most common hook-end wiper arms on both front and rear. See sources and related links below for installation videos. Also, purchase the replacement blades first and there will be additional instructions/illustrations on the replacement packages. Locate and press the tab or button where the wiper blade is inserted into the hook of the wiper arm and pull wiper blade out of hook. You may have to rotate and flex the blade to make enough clearance for the hook to pass through.
The Chrysler Cirrus was only built from 1995-2000. The washer bottle is under the hood on the driver side.
It is easiest to replace the back wiper blade by carefully prying off the cap at the bottom of the wiper and then remove the whole wiper arm. After that you will be able to easily replace the wiper blade per the instructions given by the wiper blade manufacturer. Once you have done that, simply reattach the arm and snap the cap back in place. This process will take you less than five minutes.
It is under the wiper arms.It is under the wiper arms.
The rear blade is a fairly easy installation. Take a close look at the mount which should be a hook-end wiper arm. See sources and related links below for info on the wiper blade and installation videos. Its literally a snap once you have the right part and you see it done once.
The wiper cowl is the area at the base of the windshield that houses the wiper motor.