Want this question answered?
2008 Chevy Aveo hold 11 US gallons.
12 Gallons
I have a 2005 and it holds about 12 gallons.
The hold light refers to the hold button on the shifter module. It means the transmission holds the lower gear revving up the rpms and won't shift to the higher gear. Seeing the light means the button has been engaged. Push it to turn it off
Remove the bolts that hold down the battery, remove the negative, remove the positive, and then pull it out. To install, do the following steps in reverse order.
4qts
A steady on "Hold light" means you pressed the hold button next to the shift lever, repress to disengage. A flashing "hold light", usually accompanied by the flashing check engine light means the car is in limp mode. Limp mode stops the transmission from switching to forth gear and engages at 35 mph. Check the Manifold Absolute Pressure sensor wiring, should have 5volts between the outer two wires with ignition turned on and the middle wire to outside wire voltage should change 1-5volts when you start the vehicle, also check the vacuum line for cracks. Check the Throttle Position Sensor connector. If both are good remove the plastic cover from the top of the engine and you will see the Camshaft Position Sensor between the camshafts on a 2005 or earlier Aveo disconnect the plug check the ohm reading between the pins it should be between 460-620 ohms. If none of the above finds the problem then it probably needs a relearn procedure on the cam position sensor, this can only be done at a dealership. Disconnectinng the battery for 15 mins usually resets aveo service lights if the problem is still there the flashing hold light will come back on.
10 gallons
Open the tail gate and look at were the straps that hold the tail gate are at on the sides of the bed. Now look at the 2 Phillips screws and remove them then the light will come out.
open the hood there two clip that slide up they hold base light houing. open the hood there two clip that slide up they hold base light houing.
Light assembly cover in the cargo compartment. Remove the lightbulb connector. Take hold of the lightbulb, push in and turn at the same time. The lightbulb will come out. Reverse the process to install the new lightbulb.
look on the top of the light right where the hood close it should be two wings they turn left and right the hold light globe will come out so be carefull,then the build fits in the globe