the pressure is hot water ,if it is air you have a head gasket problem.check your oil if its milky or foamy brown have it repaired ,or engine will be ruined.
The lower radiator hose is located at the bottom of the radiator.
In most cases the lower radiator hose feeds the water pump. The upper radiator hose feeds the radiator.
No, you do not have to remove the engine to replace a radiator hose.No, you do not have to remove the engine to replace a radiator hose.
a hose clamp
drain the radiator down below the top hose and unhook the hose from the radiator and the engine and pull the hose off.
Look on top of the radiator and follow the hose from the radiator to the thermostat housing. Look on the bottom of the radiator and follow the hose up to bottom of the block.
The lower radiator hose supplies the water pump. The upper radiator hose supplies the radiator.
Upper is hose connected to top of radiator, lower is hose connected to bottom of radiator.
Either the radiator hose is loose where it connects to the radiator or there is either a small hole in the radiator or in the radiator hose. Try checking the hose to see if it's loose or check for small holes in the hose or radiator.
Drain off the radiator coolant into a clean drain pan. Loosen radiator hose clamps. Remove radiator hose. Install in reverse order.
The thermostat has not opened yet.
Remove the bottom radiator hose. Put a garden hose into the top of the radiator. Allow the garden hose to run until the water coming out of the bottom of the radiator is clear.
Drain the radiator in the 1999 Blazer. Loosen the hose clamps at each end of the radiator hose. Gently twist the hose and pull the ends to break free. Replace with a new hose and clamps.
The radiator hose is held in place with a clamp on each end of the hose. Turn the clamp screw to the left. The clamp will become loose in the hose can be removed. Reverse the process to install the new radiator hose.
if there is no drain petcock on lower radiator tank, removing bottom radiator hose at radiator is the only way to drain radiator
Under where the upper radiator hose hooks to the engine.Under where the upper radiator hose hooks to the engine.
At the engine end of the upper radiator hose.At the engine end of the upper radiator hose.
Remove the bottom radiator hose on your 1996 Chevy Lumina radiator. Put a water hose in the top of the radiator. Allow the water hose to run until the water draining from the bottom of the radiator runs clear.
You have a top radiator hose and a bottom radiator hose.
Between the bottom radiator hose and the radiator. On the engine side of the hose.
The radiator hoses are held in place with a clamp. The clamp goes around the hose and can be tighten with a screwdriver. Loosen the clamp on each end of the radiator hose to remove the hose.
The thermostat connects to the top radiator hose on a 1996 Toyota Corolla. The bottom radiator hose connects to the water pump.
Drain the radiator. Remove the lower radiator hose from the motor. Unbolt the hose inlet, and remove the thermostat. Replace the thermostat and the inlet, the hose, and refill the radiator.
Under the housing where the upper radiator hose attaches.Under the housing where the upper radiator hose attaches.
Drain the Mercury Tracer radiator into a pan. Loosen the clamps at the ends of the radiator hose. Wiggle the hose to free the ends. Slide the hose off and replace it. Tighten the clamps an refill the radiator. Dispose of the old antifreeze as it is toxic to animals.