Want this question answered?
Your float is syuck or the needle is not seating, a common problem with the bayou, eBay sells a aftermarket carb with stock specifications, cause you can keep rebuilding it but it still won't seat.
2.2 litres of oil the sight glass is down beside footbrake there are two level marks keep between marks good luck from IRELAND
If the axle is pulling out of the trans, you proably have a failed motor mount. That lets the engine and trans move around to much.
The houses on stilts over the bayou waters are called stilt houses.æ These houses are built on stilts to keep flood waters and vermin out of the home.
Keep Pulling....
Born on the Bayou and Keep Chooglin' On were the two CCR songs in "The Expendables"
clutch needs adjustment.
You get a coach, train, and keep practicing.
The timing marks on a Kawasaki Mule 1000 is that 1 cylinder can pull plug #2. When wet, pull #2 plug wire to keep it running.
No. It's held by a nut at the end of the axle.
Epoxy the wheels to the axle.
there are set screws the allow there wheel to either move forward or backward and then lock the rear axle in place when done.. lossen the up and then lossed the nuts on the axel make sure you watch the ticks on the top of the swingarm make sure you keep them lined up the tighten done the nut screws and then tightin done the set screws to keep it from moving