answersLogoWhite

0


Best Answer

Fitting that holds pop-up assembly tight to drain body, or, tailpiece, needs tightened. Tighten fitting enough to stop leak, not so tight that pop-up assembly won't operate properly.

User Avatar

Wiki User

12y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: Why does the sink leak around the connection where the Pop-Up Assembly attaches to the Drain Body?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

Connection of washer drain hose to tub drain?

Connection of the washer drain hose to the tub drain is very important. This will help prevent leaks for example.


Where is the oil drain plug on a 1986 883 sportster 1000?

There is a rubber line that attaches to the bottom of the oil bag. Pull that line and the oil will drain


How can you repair a leak that is visible on the side of your garbage disposal under your sink?

If the sink/sink drain fitting connection, sink drain fitting/disposal connection, dishwasher/disposal connection, disposal/drain elbow connection are what are leaking they can either be tightened or have gaskets replaced or other sealing methods used. If the disposal is leaking elsewhere the disposal needs replacement.


Siemens dishwasher will not drain?

If the dishwasher is hooked into a garburetor, there is a plug in the garburetor where the hose drain attaches that needs to be knocked out. The drain hose might be plugged where it joins to the plumbing drainage. The other problem, plumbing-wise, is the drain hose has to be fed as high as it can go under the sink and back down into the drain.


What drain assembly is needed two hole kitchen sink?

A double drain assembly. They're usually made of plastic now and you will have parts that are longer than they need to be. Just cut off the excess with a hacksaw.


How do you drain the rear differential on a Cub Cadet Volunteer?

You have to remove the diff assembly


How do you find the torque converter drain plug in a 1993 ford crown Victoria?

Sorry, as far as I know there is no drain plug for the converter. According to the service manual, the drain plug is located on the converter assembly. Just looked at my spare transmission from the 93 Grand Marquis and I can see the plug on the converter assembly. Turning the assembly will rotate the drain plug to the converter housing access plug which is visible from under the vehicle. Hope this helps.


Where is the drain on a Holden radiator?

Remove radiator lower hose from radiator connection and allow coolant to drain into a suitable splash tray. Holden radiator Do not Have drain plug


How do you clear ac drain on trailblazer?

I made an adapter that attaches to my shop vac hose on one end and the other end attaches to the small plastic nipple on the vehicle where the condensation drips out. This way the crud gets vacuumed out.


Where is the radiator drain plug on a 92 acura integra?

The drain plug is on the drivers side of the radiator. It is almost straight down from the headlight assembly.


Does school drain your battery?

School does drain your battery because the satellite connection in school has been made to drain your battery in cell phones and any type of electronic device.


Where is the radiator drain cock on a 1996 Chrysler Cirrus?

You can get to it pretty easily if you remove the passenger side fog lamp assembly (two screws). You might also want to remove the horn assembly (attaches to the frame with a single screw). Once these are out of the way, you can easily reach the petcock with a small pair of pliers or your fingers. If you're careful, it will come out easily - but remember, it's a plastic part so don't be too rough on it.