0
Why does the temperature light come on when you start your beetle and stay on for a few minutes?
Wiki User
∙ 18y ago
because the engine is cold. after it warms up the light goes off. Cute! But what causes the blue light to come back on even after you've been driving for a while?
Wiki User
∙ 18y ago
Add your answer:
Earn +20 pts
How do you fix the air bag light that is on after start the car in a 2000 new Beetle?
Bought my used 2003 Beetle with this light glowing & after 2 trips to the DEALER it was determined to be the seat belt latch on the drivers side.
How do you fix a water leak on the 2000 VW beetle?
after 15 minutes when i start my car water start leaking apparently hoses radiator look fine
Coolant level is ok but the temperature light is on when cold start?
Answer: My brilliant cousin reckons when you first turn the key on and start it up, it just tests whether the temperature light is working.
What insect beetle start with letter u?
uruguayan beetle
What is cooking time and temperature for mini muffin brownies?
Lower the temperature 25 degrees and bake for 10-15 minutes. Start checking after 10 minutes.
What Is the life of the beetle?
first you start out with the egg. then the larva(mealworm). then a pup.Last but not least the beetle!!!!!!!
Why would the blue temperature light in a '99 VW Beetle start flashing but stop after turning the car off for a minute and turning it back on?
Could be that the coolant level is a bit low and the flashing light is telling you this. The level will drop when the fluid is running thru the motor. When you turn the car off the level rises back to nominal level. Dan
What bugs start with d?
deathwatch beetle, .......
When did the term super beetle start?
1971
How do you reset security light on a 1999 GMC Savana 2500?
Attempt to start the truck by turning the key on the security light should start flashing. Allow the light to flash for 10 minutes light should eventually go off on its own after 10 minutes. Then Cycle the keyswitch again the security light will start flashing again allow this to happen for 10 minutes and cycle the keyswitch one more time after 3 complete cycles you should be ready to turn the truck on and that will be all set.
What causes a tree to bloom?
Light and temperature causes a tree to bloom. During the spring when the temperature warms up and there is more light, the trees will start to have their flowers blossom or leaves begin to grow.
How Do you Bleed The Coolant System On A 1998 2.0 Beetle?
Start by taking the top off of the coolant overflow reservoir. To bleed the system, run the 1998 VW 2.0 Beetle about 10 minutes, then check the coolant level. Add coolant if needed, then replace the reservoir top.
