answersLogoWhite

0


Best Answer

probably a bad blower motor--which you have to remove from under the hood

User Avatar

Wiki User

16y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: Why does the vent on a Pontiac Grand Am GT only work for one setting and stays that way for no matter what setting you put it on?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

Where is the fuel pump for a 96 Pontiac Grand Am?

GM (who builds Pontiac cars) usually puts the fuel pump inside the fuel tank. It's tough to get to there, but it stays cool.


What is an integral setting?

Is a setting that stays the same.


What does it mean when the dash board brake light stays on pontiac grand am?

Either your parking brake ( emergency brake ) is on or the brake fluid level in your brake master cylinder in your engine compartment is LOW


Your 2004 escape stays on defrost no matter what setting it is on?

Check the Escapes blend door system. The door is not working properly and causing all air to go to the defrost.


1995 eagle vision heater stays on no matter the temp setting and fan speed why?

your fuse is messed up. we just had the problem replaced it and we are good to go. its about $7.00


What stays indoors no matter how many times you put it out?

What stays indoors no matter how many times you put it out?


Check engine coolant light stays on until engine heats up on 2002 Pontiac grand prix 3.8 liter engine?

Check the engine coolant... Is it full? yes coolant level is full


My 1999 Pontiac grand am se 6 cylinder service engine soon light stays on. The car also stalls out when stopping sometimes?

There are many causes for a service engine light. You need to have it checked for codes. Then you can diagnose from there.


Can matter be changed or moved?

Matter can not change. Its weight always stays the same NO MATTER WHAT, and it can be moved


What stays the same no matter where it is located?

"mass"


What if your pontiac grand am's blinker works on the left side but not the right side it just stays solid when clicked. i have checked blubs and flashers. what could this issue be?

Replace bulbs (double filamented smaller for turn signals) Check sockets for corrosion


Is matter ever used up?

Einstein stays no.