Because someone has connected the hot water line to the cold service. They are reversed. I'm not a plumber, so I don't know if the first answer is correct or not. However, our landlord replaced our shower fixture with one that could be adjusted so that it prevented burns. He was pretty proud of it because it was supposedly an expensive model & it was safer for kids. The plumber that installed it used the default settings, I think. But I was unhappy with it for the longest time because I could never ever ever get a HOT shower out of the thing. And I didn't want to turn the water heater up because that uses more energy & runs up the utility bill. Eventually, I got brave enough to pop the cover off the shower control handle and discovered the little safety lever to adjust the water from cooler to hotter. Everything worked fine after that.
it depends on what type of shower, but the usual mistake that is made is that the cold water supply to the shower has been taken from pipes in the bathroom such as the bath tap but they should be taken from the rising main ( direct supply).
This is becauze of Expansion and Evaporation of water. As you make the water into tiny droplets it increases the rate of evaporation and hence causes a cooling effect.
Yes, it can also cross through a two handled faucet. Both the hot and cold sides of the faucet must be on and the flow of water must be stopped or greatly reduced on the outlet side of the faucet. This can occur when a hose with a spray nozzle is attached to a laundry tub faucet with the faucet on and the spray nozzle off, or when a shower faucet is on but the shower spray head is off. When another cold water outlet in the system is turned on then the pressure on the cold side of the laundry tub or shower faucet in question could be lowered below the pressure on the hot side and hot water can flow into the cold water side. There are faucets which have integral check valves which prevent this from occurring. WWW.WOODBRIDGEPLUMBING.COM
because they have different densities
Electric showers only take water from the mains cold water supply. They heat the water when you turn the shower on, by passing it over a heating element inside the shower - in a similar way to how a kettle works. When you shower, you don't use up and stored hot water - so electric showers are ideal for families and households where there is a limited supply of hot water. Electric showers are always ready to use, any time of the day or night
That is because warm air outside the glass contains moisture and that moisture condenses on cold surfaces since cold air on the glass surface cannot hold as much moisture as warm air. It is the same effect as fog on the bathroom mirror after running a hot shower.
Do you have hot water at other fixtures in the house? If not you have a water heater problem. If yes the Shower valve needs to be rebuilt if it is a bressure balanced faucet the concentration should be on the pressure balancing spool area of the faucet.
The plaming tubes are all conected.When the cold water run in kitchen the cold water at the shower become less,so with less cold water at the mix cold-hot (the balance is desterb),making the water hoter.Same if you turn on the hot in the kitchen the water will be colder in the shower.
the water is hot. when we get out we're hella cold
On single handle shower valves, designed to let cold water first and turn handle farther to mix hot water to desired setting. If hot water turned on first, possibility of getting scalded. If seperate hot/cold handles for shower, shower valve needs work.
When you take a shower, you're mixing a combination of hot and cold water to make a comfortable temperature for the shower water. A toilet draws only off the cold water system. In older or poorly designed plumbing systems, when you flush the toilet, the cold water is pulled by toilet, so the water coming through the shower is only drawing from the hot water tank.
A malfunctioning water heater can cause hot and cold water to surge through the shower heat. A faulty water pump can also cause this problem.
a cold shower
A 'Triton Electric Shower' is a shower that can draw on a cold water supply and heat it on demand. It differs from other showers in the fact that it can use cold water and heat it itself, instead of relying on a boiler to heat the water first.
Run a new cold supply line from the source. This will drain less pressure from the the cold shower line.
No cold water will just give you muscle spasms and cramp
Water absorbs heat from its surrounding as it evaporates.
This is not an uusual as when the toilet is flushed more cold water is drawn usually from the cold water pipe that suplies the shower with cold water so generaly the water under the shower gets hotter. The only way to stop this from happening is to lay an extra pipe all the way to the ater suply point, or fit a pump to maintain the presure
Incorrect pipe size installations