The turn signal wiring goes up the steering column. Turn signal bulbs are also used as brake lights and the brake light signal goes through the turn signal switch. If there is a loose connection or worn wire in the steering column, the tilt would cause problems.
i cannot get the brake lights to work
The multi function switch is inside the steering column , for turn signals etc.
if turn signals are working , and brake lights not working, i would replace the stop light switch on the brake pedal
The instrument panel is the gauges and warning lights that are in front of the driver and behind the steering wheel
The problem that I had with my 2001 Ranger rebuild was I had tail-lights and back up lights along with brake lights. No turn signals or hazard lights. More than likely, it is a bad turn signal control arm. There is also a relay box under the dash. My problem was that the relay had gotten wet and had rusted inside. As soon as we replaced this, I had turn signals and hazards. Hope this gives you a reference where to start your search. Good Luck, Dan
The button that turns the flashers on is located on the steering column directly behind the steering wheel. It is located on the top or bottom right depending on model. The flashers themselves are your turn signals working in unision.
Sounds to me like the turn signals and the heater fan may be on the same fuse?? Jack
need locations of steering column brackets on a 1998 ford ranger
You can remove the steering will, on your Ford Ranger pickup truck, by removing the steering wheel pin. Remove the wiring harness and the steering wheel will come off.
How to change dash lights on a 95 Ford Ranger?
yes it will i did it
Power steering fluid.