answersLogoWhite

0


Best Answer

Check the firing order, you may have some crossed wires.

User Avatar

Wiki User

14y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: Why does your 1997 GMC suburban misfire and backfire at the same time?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

What trucks use the same hood as a 1997 Suburban?

97 chev silvarado 1500 i think


Will a 350 vortec from a 1998 Tahoe fit in a 1997 suburban?

Yes the are the same engines. That is a direct bolt in


Is there a bolt in replacement Rear Axel with disc-brakes for a 1997 Suburban such as a 2001 Suburban with the same axel ratio I'm trying to get rid of the drum brakes?

SummitRacing.com has one.


Can the seats from a 1997 Chevy Suburban fit in a 1990?

yes 90 trough 99 are the same base models


Is turn around and backfire the same?

Yes, they have the exact same meaning.


Does a 1999 suburban and 2000 suburban have the same gas tanks?

Yes


What size rims for a 1997 suburban?

My 98 are 15 inch...I think the 97 is the same. If you want to modify it, you might try going to the tire rack (tirerack.com).


Are computer the same in a 94 suburban 1500 and 2500 suburban computer are they interchangeable?

NO they are not.


Can a rear end from a gmc 1997 suburban fit a 1997 Chevy suburbsn?

Yes the rear ends on those 2 will be a direct swop. If it is a 4-wheel drive then you MUST make sure that the gear ratios are the same.


Will the programming of a 2001 suburban be the same as a 2002 suburban for the key less remote?

Yes it is.


1997 ford excort number 2 cylinder misfire what is wrong?

In any car, if you have a specific cylinder misfire, check the spark plug, spark plug wire, fuel injector, and compression. The computer could also have a problem. You will need to consult the detailed manufacturer's diagnostic chart for that, but the basics remain the same.


1997 suburban wont down shift when accerating?

I have a 1999 GMC Suburban with the same problem but it did not show up until I had removed all of the wiring harness from the engine for a cylinder head job. I am going to look at the throttle position sensor and wiring connector tonight.