I just replaced the timig belt on my 97 Mercury Tracer 2.0, the timing marks are lined up, but i still have no compression at all. Your input would be greatly appreciated. Im asking the question, apparently I'm in the wrong area.
what could be the couse for a bad gas millege in a 1991 mercury tracer?
my 1997 mercury tracer ran hot and now will not start what could be the problem?
A broken serpentine belt.
You could try recharging the battery, or having the connections checked by a mechanic.
If your 1997 Mercury Tracer has a battery light that blinks on and off while the car is running, it most likely means that the battery is not charging. This could be an issue with your alternator.
Tie wraps can be used to replace a stock radio wiring harness in a 1991 Mercury Tracer. The wires can be replaced with other radio wire from an automotive parts store and the tie wrap can hold them together.
you could have a short between the two.
more likely a supension or tire problem, depends on where you're feeling it vibrate.
Check the engine. ===================================================== There is a problem with something that effects the emissions of the engine You need to have the vehicle scanned for any trouble codes to help diagnose and then repair the problem
No, the parts on these vehicles are not interchangeable/compatible with each other. You could use Mercury Tracer parts though.
You could check the switch on the brake pedal, sometimes they need to be adjusted so the cruise will stay on.
On a 1997 Mercury Tracer : It could have the Anti-lock Brake System ( assuming the warning light bulb works , there will be an " ABS " light in the lower part of the dash , between the " BRAKE " warning light and the speedometer , that you should see when you first turn the ignition key to the RUN position , just before starting the vehicle , to prove that the bulb works )