Fuses That "Blow" Repeatedly
Without being able to "hands on" troubleshoot the circuit served by the repeatedly blowing fuse, none of us can identify the specific defect which is causing your problem.
Therefore, the following generic answer can be applied to any electrical circuit, whether in a vehicle, or in a building, or whether alternating current [AC] or direct current [DC].
Fuses [and Circuit Breakers] are safety devices designed and installed in electrical circuits TO PROTECT the conductors [wires] and other components from short circuit conditions and/or overload conditions which cause an extremely large flow of electrical current [measured in Amperes], which causes overheating of the conductors that results in damage to the insulation and the conductors.
And in a worst case scenario, the probability of a FIRE which could destroy the vehicle, house, or other structure in which the circuit is located.
When a fuse or Circuit Breaker [and replacement fuses, or "tripping" Circuit Breakers] "blow," especially if it happens repeatedly, is an indication of an UNSAFE CONDITION in that circuit, usually a short.
The fuse or circuit breaker is doing what it was designed, intended, and installed to do, protect the conductors and components of the circuit which it serves.
The proper "fix" is for a qualified technician, who knows what he or she is doing, to troubleshoot the involved circuit, find and identify the defect, and make proper repair [s], BEFORE replacing the fuse again [with the properly sized fuse or before resetting a circuit breaker].
Some ignorant people will suggest installing a larger fuse or breaker to solve the problem, BUT that will only increase the hazard, not correct it.
Do not follow "bad" advice by installing a larger fuse in a misguided attempt to correct the problem. To install an over-sized fuse would almost guarantee damage to the wiring and an electrical system fire.
fuse keeps blowing
Obviously, if any fuse keeps blowing there is a serious fault in that circuit.Take it somewhere they can fix it.
A fuse that keeps blowing is an indication of a malfunctioning ignition. The ignition may be the culprit or the wiring leading to the ignition may be the problem.
Motor hasseized.
2006 Ford Focus rear defroster keeps blowing the fuse immediately after replacement
If you have a trailer socket it might be full of water. Or there is a short circuit in the fog loght cluster
Compressor may be locked up.
You need to find the cause of the short.
Because they have a weak supply in the engine.
There is a short in the system somewhere. Check all the wiring.
your car wont start!
my Chevy cobalt 2005 keeps blowing the fuse everytime i put my windows up or down i had the door wireing replace a new window motor replaced new switch and it still blows the fuse what can the problem be