answersLogoWhite

0

door seals are on outside of the doors and prone to perish and split causing water to enter

User Avatar

Wiki User

16y ago

What else can I help you with?

Related Questions

What is the timing setting's for a Mazda 323 E5?

Mazda 323 familia valve timing set up


Will the wheels from an M reg Mazda 323 fit an R reg Mazda 323?

4stud vs 4 stud, yes it will, 4 stud vs 5 studd, it will not. for all the 4 stud Mazda 323(f) from by 88 up to 2001 will fit


Where is the speedometer cable located on a 1987 Mazda 323?

The speedometer cable on a 1987 Mazda 323 is located on top of the transmission and travels up to the dashboard. It helps the vehicle's computer monitor speeds constantly.


Where is the pick up coil located in a Mazda 323 and how much to replace?

Usually it's inside the distributor, depending on the kind of ignition used.


Do the fans on your Mazda 323 only work when the engine reaches a certain temperature?

almost all cooling fans run temp to help get engine warm up very quickly and may turn going the road on cold days to keep temp up in the engine


Where is the fuse box on Mazda 323?

Its located way up underneith the dash on the clutch side. there is a small black plastic cover that pops off


How do you keep a mirror steam free?

You can prevent a mirror from steaming up by rubbing a small amount of shaving cream on it and then wiping it off. Alternatively, you can try using a mixture of vinegar and water to clean the mirror, which may help prevent it from steaming up in the future.


Why does your car keep steaming up?

Your heater core has a hole in it. Antifreeze is leaking out and evaporating onto the cold windshield and glass areas.


Is the timing mark on the cam sproket of Mazda 323 hatchback 1979 at sharp 3 'o' clock position?

have key way at top strate up and down


Why don't the taillights radio air conditioning fan and horn work on a Mazda 323 1988 after replacing alternator and battery that burned up?

Check the fuses, they could be fried.


Where is the cooling fan sensor on a 1989 323 Mazda and how do I check it engine heats up when I am stopped fine when moving.?

The thermo fan sensor is on the thermostat housing, right below the distributer.


Why is my Mazda 323 keep burning the engine coil and wouldn't go up the hill..?

If your Mazda 323 is burning the engine coil and struggling to go uphill, it could be due to several issues. A faulty ignition system, such as a short circuit or an overload from a malfunctioning coil or wiring, may cause excessive heat and damage. Additionally, poor fuel delivery or a clogged air intake could lead to engine performance problems, making it difficult to climb hills. It's advisable to have a mechanic diagnose the electrical and fuel systems to pinpoint the exact cause.