0
Where is the cooling fan sensor on a 1989 323 Mazda and how do I check it engine heats up when I am stopped fine when moving.?
Wiki User
∙ 14y ago
The thermo fan sensor is on the thermostat housing, right below the distributer.
Wiki User
∙ 14y ago
Add your answer:
Earn +20 pts
Where is the ECT sensor on a Mercury Sable?
location of engine cooling fan sensor
Your cooling fans run all the time when the engine is running.?
engine cooling fan should not do this - bad temp sensor likely
95 aurora oidsmobile were is temperature cooling sensor at.?
The 1995 Oldsmobile Aurora cooling system temperature sensor can be found on the front of the engine. The sensor will be above the thermostat housing.
Why does the cooling fan turn on when engine is cold?
temperature sensor is bad
Engine cooling fan on all the time?
bad temperature sensor
Where is the cooling fan sensor on a 1999 Dodge Caravan?
The engine coolant temperature sensor is the two wire sensor near where the upper radiator hose attaches to the engine.
What is the tip-over sensor on a harley?
If a running Harley gets laid on a side, either while moving or stopped/idling, the tip sensor kills the engine. the ignition switch must be cycled off then back on to start.
Cooling fan sensor for 1996 grand prix?
The 1996 Pontiac Grand Prix cooling fan sensor is located on the front of the engine. The fan sensor can be found just above the thermostat.
Location of thermostat sensor to turn on engine cooling fans?
Most vehicles locate that sensor close to the thermostat housing.
Where is the location of cooling fan sensor that turns on the cooling fans - 2000 Corvette?
Where is the engine cooling fans sensor located on a 2000 Corvette ? Screwed in the driver side cyinder head just behind the Alternator. this is referred to as the temperature sensor. Hope this helps. Mike
What would keep the engine cooling fan from coming on in a 1990 Acura Integra GS?
The cooling fan is activated by a sensor, and possibly a relay. Most likely the sensor has gone bad.
How do you replace the coolant level sensor on a 1995 thunder bird?
PATH: Engine Cooling > Coolant Temperature Sensor > Removal & Installation Removal & Installation Drain the engine cooling system slightly. Disconnect the negative battery cable. Detach the wiring connection from the sensor. Remove the coolant temperature sensor from the intake manifold. Clean the sensor area of any debris. To install: Install a new sensor into the intake manifold. Tighten the 6-14 ft. lbs. (8-19 Nm). Attach the sensor wiring to the unit. Connect the negative battery cable. Fill the engine cooling system with a 50/50 coolant water mixture. Start the engine and top off the cooling system.
