It is most likely the thermocouple that is bad. That is what keeps the pilot light on. The thermocouple is the small tube that sits in the flame of the pilot and runs to the control valve.
Same as any hot water heater. Turn the gas valve to off.
Turn knob to PILOT, press button down and light the pilot; hold button down for 60 seconds and release - pilot should remain lit; turn knob to ON. If pilot does not remain lit, turn knob to OFF, wait 5 minutes and try again, If pilot still will not remain lit, replace the thermocoupler.
You don't. If the heater has an electronic spark, then it doesn't have a standing pilot to light. The spark lights the pilot when there is a call for heat, which in turn lights the burners. If the heater is on and the pump is RUNNING, the heater should light automatically when the water temperature is lower than the heat setting.
If your water is turned off you can't cook, bathe, drink or flush. If you mean temporarily, nothing serious. You probably want to turn your water heater to pilot and often your pipes will fill with air which will cause a lot of sputtering when your turn the water back on but cause no harm.
There is no such thing as a '93 Pilot. In 2003 The Honda Pilot replaced the earlier Honda Passport.
the pilot light in my fireplace is working but when i turn the switch on (new switch) it wouldn't fire up
Hot air balloons have a gas heater that is generally powered by propane. When the pilot turns the heater on, the balloon will fly high due to the hydrocarbon chamber that allows the pilot control of ascent and descent of the hot air balloon.
Not if the water heater is electric
YES and No Yes if you are going to be working on the gas water heater and No if you are working on a cold water line and if you are working on a hot water line you can shut off the gas or electric to the water heater so in case your water heater drains but what I usually do is just turn the water heater's water supply valve off.
Check temperature setting on tank , you may need to turn it from warm to hot. Make sure your water shut off valve is turned on above the hot water tank on the hot water side.Another possibility is the heating element:If you have a gas heater, did the pilot light go out? If so, relighting the pilot will take care of the problem.If you have an electric heater, was it restarted in the right order? (Don't turn the circuit switch on unless the tank is filled-- if tank is empty when power restored, the heating elements will burn out and need to be replaced.)
There should be a dial on the front of the heater that you set the temp. with.
No. Turn off either electric or gas to water heater so it won't continue to heat water unnecessarily. Turn back on when water outage is over.