Because you have a misfire on cylinder #2. Can be defective spark plug, bad plug wire, or bad coil if equipped with coil on plug. Can also be a burnt valve, blown head gasket or bad fuel injector if applicable.
Have the car re-scanned. P0310 is cylinder #10 misfire. This code is no applicable to the Accent.
car shacks
An engine cylinder misfire is what happens when combustion is incomplete. How much it costs to fix will depend on the type of car and the year it was manufactured.
It will have a cylinder misfire or will not run at all.
A misfire is when one of the cylinders is accelerating without actually doing anything, it's just a dead-cylinder. In order to fix this you need to tighten the cylinder or adjust the engine connector.
PO300 is random cylinder misfire. This can eventually destroy your catalytic converter and the O2 sensors. So, you need to have this repaired immediately.
Cylinder misfire. Possibly failed or failing engine mounts.
Possible cylinder misfire and/or failing engine mounts.
If your check engine light is blinking , that means an engine cylinder misfire has been detected - your vehicle would need to be scanned for any trouble code(s) to determine which cylinder or cylinders are misfiring
Yes, very much so. If you can check via a code reader which cylinder is misfiring try swapping the plug in that cylinder to a different cylinder and see if the misfire shifts with it. Failing that it could be a cool pack or ignition lead at fault.
Misfire on more than one cylinder. Start by replacing your plugs and plug wires. If that does not solve the problem, run a compression test to determine if you have a burnt valve.
Misfire is caused when a cylinder doesn't ignite its fuel mixture. Suspect a bad plug, coil, or wire. This will not be caused by a mass airflow sensor, that can cause a rough idle or bad fuel economy, but will not cause an individual cylinder to misfire. Driving with a continuous misfire condition will eventually destroy your catalytic converter. If your check engine light is flashing you are doing serious damage to your cat converter.