0
What else can I help you with?
Why would an automatic gear stick in 1st?
An automatic gear would stick in 1st if there is an obstruction. Gears can sometimes break off and cause motion to stop entirely.
If you are driving a stick shift car how do you know when to change into 5th gear?
Normally you have to listen to the RPM rate to know when to change into ANY gear on a stick-shift/manual transmission car. Changing between fourth and fifth gear isn't any different from changing between, say, 3rd and 4th. I wouldn't bother keeping too much of an eye on the RPM meter, because if you listen closely the engine will tell you when it is necessary to change the gear.
How do you down shift gears in a stick shift?
The gear stick has a diagram of where to move the stick to engage a certain gear. For example, if Gear 1 is in the top left corner, you must move the stick to the fair left, then forwards to engage first gear. Oh, and you have to push down the clutch each time you change gear.
Why does my car jerk after changing gear and accelerating?
have your transmission checked sometimes torque converter clutch isn t locking or unlocking properly
How does a gear stick work?
nathan
Why does reverse gear not work in barina?
You need to lift the collar on the gear stick to engage reverse gear
Why does my Toyota Tercel 1995 160000 km automatic transmission sometimes jump out of gear during acceleration?
I posted this question, as it turns out the auto transmission just needed a good service, it hasn't jumped out of gear since the service, and is even changing gear smoother.
Is it safe to drive a stick shift it skip second gear?
If stick shift jumps outta second gear is it okay to drive the car?
Manual stick shift BMW what cause to shake when you shift the first gear?
manual stick shift BMW what cause to shke when i change in to the first gear
How do you remove gear stick for Nissan qashqai j10?
To remove the gear stick from a Nissan Qashqai J10, first, ensure the vehicle is in neutral and disconnect the battery for safety. Carefully pry off the trim surrounding the gear stick, usually held by clips or screws. Once exposed, detach any retaining screws or clips securing the gear stick assembly, then pull the gear stick upwards to remove it. Make sure to disconnect any electrical connectors if present before complete removal.
What happend is I don't use the clutch when I shift?
If it is done right without grinding the gears, nothing. You need to take the load off the gearbox, by lifting of the gas slightly, when changing up. Pause in neutral before easing the next gear in. Changing down is harder to do smoothly. Lift off the gas, pause in neutral, increase the revs to what you think it should be, for the speed in the next gear. Ease the stick into the next gear down.
What does transmission slip feel like?
put it in gear, sometimes it goes sometimes not. 2 gear sometimes goes sometimes not,,, as your driving along, suddenly its like its in nutrel
