I had the same problem and I found it to be the blower motor resister. This is what controls the blower motor settings. You will have to find out where it is on yours.
Settings for MC.
my heat doesnt work in my2000 lincoln ls what causes this
could be a sticking thermostat.
you have to when you turn it on go to the settings and click recalibrate and if it doesnt work within ten minutes it is broken!
Go to jailbreakme.com and then slide to jailbreak. If that does not work then go to jailbreakme.modmyi.com If that doesnt work then go to settings, and clear cache, clear history, and clear cookies. If that doesnt work then your screwed
A pool heater typically uses either gas or electricity to generate heat, which is then transferred to the pool water through a heat exchanger. The heated water is circulated back into the pool to raise the overall temperature. The heater can be adjusted to maintain a desired temperature setting for the pool.
Check to seee if it has anti freeze.
take out your graphics card hit it with a sledge hammer. factory settings is when the graphics card doesnt even work. honestly just kidding about the sledge hammer
the 1999 wrangler's heat only worked on high,but now it don't work at all.
Check your settings...the passenger and drive have TWO different temperature settings.
A heat engine converts heat energy into mechanical work. It operates by taking in heat from a high-temperature source, using it to do work, and then releasing the remaining heat to a low-temperature sink. The efficiency of a heat engine is the ratio of the useful work output to the heat input.
It does work .... unless the wound is too high to place the tourniquet above it.