it doesnt work, it breaks it doesnt work, it breaks it doesnt work, it breaks
The pool heater may be cycling off and on before reaching the set temperature due to a possible issue with the thermostat, water flow rate, or a dirty filter restricting water flow. It could also be caused by a malfunction in the heater's pressure switch or temperature sensor. Consider having a professional inspect and service the heater to diagnose and address the issue.
It works this way. Even if you could set the thermostat at 200 it will not heat the water any quicker. It sounds as if you have an undersized heater. A larger heater will heat the water faster if your system can upgrade to the larger size heater. Your house will not heat up any faster if you set the thermostat to maximum. It is the output capacity of the heater that determines how fast it will heat. What dictates heater size is: the size of the gas line. the length of the gas line run from the meter to the heater. the size of the meter. how many GPM the pump is producing. the GPM capacity of the filter. the size of the plumbing in you pool ~ 1.5"; 2"; 3" total gallons in the pool. are among a few. Just common sense here...... k
One efficient way to heat your swimming pool during colder months is to use a solar pool heater. This system uses energy from the sun to warm the water in your pool, reducing energy costs and environmental impact. Additionally, using a pool cover when the pool is not in use can help retain heat and prevent heat loss.
No, a typical pool heater requires more than 450 mV to light the main burners. Hayward pool heaters usually require a minimum of around 600-700 mV for proper operation. If the thermopile is only producing 450 mV, it may not be sufficient to light the main burners reliably.
Yes, there is a minimum flow rate requirement for a solar pool heater to ensure proper operation and adequate heat transfer. This flow rate varies depending on the size of the solar panel system and manufacturer specifications. It's essential to follow the manufacturer's guidelines to optimize the system's performance and longevity.
read the pool heaters manual.
Heaters are usually plumbed in after the filter. The pool filter/pump is what circulates the heated water. Ans: The heater will not work or fire if the pump is not running.
form_title= Pool Heater form_header= Stay warm and swim with a pool heater! What is your budget for a pool heater?*= _ [50] What type of pool do you have?*= () Salt Water () Chlorine What is the size of your pool?*= _ [50]
Maybe your filter needs to be cleaned. WHen was the last time?
Most people would want the spa hotter, so in that case there is no way to use only one heater.
Do you mean a pool that has a salt water generator? If so, any pool heater could be used.
no you need a stronger heater specifically designed for a swimming pool
A pool plumbing diagram with a heater typically includes pipes that connect the pool to the heater, a pump to circulate water, a filter to clean the water, and valves to control the flow of water. The heater is usually placed after the filter and before the return to the pool.
That depends on where you are and the quality and extent of the work.
Start with a "maxtemp pool heater" search.
Recommend 400,000 BTU heater
It depends on the temperature you have the thermostat set at. In Arizona, the heaters work even during the summers because the altitude makes a difference in how warm the pool stays.