Want this question answered?
Push the button. Use the electronic /remote door/lock opener. Use the key. Or use the toggle on the counsel inside.
I have a 2007 Mercedes and i am trying to set the garage door opener remote. Manual states press the smart button on the over head opener. i cannot locate that button.?
Your remote car has a swich in the inside take it apart and push the button over
On the inside of the keyless entry remote or sometimes on the back it explains how to do this. I believe you hold the unlock button along with the lock button for 7 seconds near the car. It will explain it on the inside of the keyless entry remote.
Yes you just press the synchronise button inside the Wii remote at the same time as you press the one in the little box by where you put your disk in. But it doesnt always work -------------------------------------------------------------------------------------------------------------- You could always take it to your nearest tech store and have them fix it for you.
your remote is buggered, you can sometimes solder the button back on, inside the remote. split the remote housing and take the chip out, you should see the button has fallen off.
where the reset button is there will be a latch, open it, inside you will see a red button. then open the battery part of the wii remote and there wiil be another red button, press both at the same time and voila!!!
The back of the remote has the instructions. Press lock button and then the top button-Press for about 2-3 seconds car will start Don't over use - remote is built very cheap and sensor inside the remote breaks. Had to solder 3X
there is a manual release button you have to pull on the inside panel of the truck on the side where the fuel flap door is located. I know that, but cannot get the darn flap open with my remote key!
Pull the key out of the plastic remote. Look down in the crack, and you will see a gray little button. Press the button down with the key you pulled out, and flip the top plastic piece upwards while holding down the gray button. The battery will slide right out after that!
There's a red button inside the remote's battery compartment and another one in the SD card slot on the console (right above the eject button and below the reset button). Push the 2 red buttons simultaneously and they will sync
The remote trunk release was optional. If it is there, you will find a yellow button inside the glove box.