answersLogoWhite

0


Best Answer

Disconnect the plug to your fan. Hook a jumper wire to ground the negative wire and a hot wire to the positive wire. If the fan doesn't work, then you can buy one on Ebay or other sources.

User Avatar

Wiki User

14y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: Why doesn't my 300d Mercedes fan work?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Continue Learning about Engineering

Will a heat pump compressor burn out if the circulation fan does not work?

If the fan outside is not running the compressor will overheat and if the fan inside the house is not running the compressor will get liquid refrigerant back to it and lock up! Neither is good for the compressor.


What is the work of strainer in fan coil unit?

To strain waste particles in chilled water


What is a story about an industrial accident?

A large ventilation fan was being repaired at a nuclear power plant. The fan was setup in a work area on the turbine deck. The protective screening had been removed. A health physics technician was surveying the fan for radioactive contamination when, due to a failure in communication, the fan was energized. The technician was sucked into the fan and killed.


How does the fan work?

If the question is about the motor fan or engine fan, the main function of this fan is cooling the radiator of the engine which in turn is cooling the water circulating inside the engine unto the radiator and back. This keeps the engine at a fairly operable temperature without overheating and damaging damaging its parts.


How does turbine work?

Steam or water, it works the reverse of a fan, where the fan pushes air down, the turbine is turned by the steam or water. there's a shaft leading from the turbine to the generator, which produces the electricity

Related questions

Why doesn't my Mercedes Benz 300D 1982 heater blower not run it only has 8v to the plug and the fan doesn't even try?

Because the relay is bad.. Or your wiring.


How do you adjust fan belt on 1996 300D?

how do I loosen fan belt to remaove alternator for replacement of alternator?


How do you change the serpentine belt on a 1987 Mercedes Benz 300D?

Its kind of a pain. I just force it. Or move the alternator. Sorry .. that sucks.. but better than nothing. I find removing the fan shroud makes it SUPER easier.


The radiator fan on my 1991 lebaron doesnt work unless i turn on the ac or defrost then push the fan then it will work for a while What is wrong with it?

The fan motor has failed and will need replaced.


How do you take a fan off of an international tractor?

when it doesnt work any more


Opel frontera overheating on idle?

apparently they are designed for cold temperatures, so the radiator fan will kick in really really late. But if your fan doesnt turn on at all either the fan doesnt work at all (power failure to fan, or fan malfuntion) or fan sensor switch is faulty.


1987 Mercedes 300d climate control air circultation fan not working what can be the problem?

check your fuses in the main fuse box first, located under bonnet in front of driver. there should be a reference in the fuse box of which fuse supplies the climate control fan. Otherwise if Ok then chk the Relay located behind the fuses


Fan Doesn't work for your 1988 Mercedes 300E?

change the resistor if the problem continues try the fan with cables directly to battery and you will see for sure that the fan need to be replaced.


How do you change fan belt on a Mercedes?

Take it to a mercedes garage


How do you install fan clutch temp sensor Mercedes?

how to install fan clutch sensor in mercedes 1984 500 sel


Where is the fan ballast on a 91 Mercedes 350sdl?

the fan blast i37


Why don't radiator fans work on a 95 Chevy Monte Carlo z34?

your driver side fan should come on at about 220 degrees which is about 3/4 way up the temp gauge and the passenger side comes on only when the ac compressor is turned on, if ur ac doesnt work then neither does ur passenger fan, if ur temp isin red and ur driver side fan doesnt come on then check your relays if ur relays are good then change ur coolant temp sensor and if that doesnt work then ur fan motor is most likely burnt out