Late Model 1979-New Ford Mustangs

Why doesnt your fuel level gauge work for your 1990 ford mustang?

101112

Top Answer
User Avatar
Wiki User
Answered
2008-02-16 05:21:01
2008-02-16 05:21:01

The float in the fuel tank may need to be replaced.

001
๐ŸŽƒ
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0
User Avatar

Related Questions


USAAF Mustang was created in 1990.


The 1990 Ford Mustang 2.3L SOHC had 88HP


There is no dipstick on the standard transmission , the fluid level is checked at the fill plug on the transmission


a full weight 5.0 1990 mustang gt weighs around 3400-3450lbs. an lx mustang can be around 3350-3400lbs.


The 1990 Ford Mustang 5.0 liter V8 engine is rated at ( 225 horsepower from the factory )


a factory 1990 mustang has an intank electric fuel pump not a mechanical hope this helps


Where is ac low pressure service port on a 1990 ford mustang


It is most likely the oil pressure sensor, located on the front of the engine block near the oil filter. There is also a slim possibility that the gauge in the instrument cluster is defective.


standard engine has about 280-345 horsepower ======================================================== A 1990 Ford Mustang 5.0 is rated at ( 225 horsepower from the factory )


yes, a hatch from a 1979-1993 mustang will bolt directly to any of these model years


It will bolt in, however, you will run into problems with the onboard computer. You will have to reprogram, or maybe even change it.


According to my Chilton's Auto Repair Manual : A 1990 Ford Mustang has a ( 15.4 U.S. gallon gas tank )


A 1990 Jeep Cherokee malfunctioning fuel gauge can be caused by a broken ground wire. The gauge will not function if the fuel float in the fuel tank is broken.


I believe the 1990 Ford Mustang 5.0 L was rated at 225 horsepower from the factory


Call autozone they usually have a list of which parts fit which years.



My 1990 GT gets around 18 city, 22 highway.


My ( 1991 ) 5.0 LX Ford Mustang always used 5W-30 as recommended


I used WD-40 after pulling the cable out of the car. You can try just pulling the cable off of the transmission, pulling the gear off, then squirting the oil of your choice in the end. It is probably best to remove the cable from the gauge cluster inside the car. That is a lot of work so you may want to try from the trans first then if that doesn't fix it work from the gauge cluster end. It worked for me 6 years ago on my 1990 mustang lx 50 and no problems since.


e303 cam is what I run and am very happy


It came from the factory with ( 5W-30 )


Yes, You may have to change the tranny support and shorten the drive shaft but it will fit.


i have a 1990 ford ranger and my fule gauge always reads full, why?


Begin by removing the wiring harness from the back of your 1990 Ford Mustang headlight assembly. Remove the headlight assembly retaining bolts. Reverse the process to install your new headlight assembly.


They are different.83-90 are the same, then they changed the style for 91-93.



Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.