answersLogoWhite

0

To reduce power loss in the cable.

User Avatar

Wiki User

17y ago

What else can I help you with?

Related Questions

How do you measure electricity and with what measurement?

With kitchen tongs. A mild tingling indicates low voltage/low amperage. Muscular spasms indicate high voltage/low amperage. Unconsciousness sans death indicates low voltage/moderate amperage. Death indicates high amperage. Good luck.


How is electricity transported and distributed?

The electricity is transported and distributed by the use of the national grid and the step down and the step up transformers.


What does copper used in solar panels?

Copper is an extremely efficient conductor of electricity with very low resistance. It virtually eliminates the loss of voltage/amperage when the electricity from the solar cell is being transferred to a battery or the power grid.


What controls the flowing of electricity?

The flowing of electricity (amperage) is governed by the internal resistance of the connected device.


What is the most electricity you can make with a magnet coil?

A coil doesn't make electricity it can however alter voltage and amperage output.


Why is primary coil in step up transformer thick?

A step up transformer converts low voltage,high amperage current to a high voltage,low amperage current. It requires large diameter wire to carry the high amperage in the primary coil.


How much electricity used by a seed dryer?

A voltage and amperage need to be stated to answer this question.


How does wind energy get transported to the user?

Wind energy is converted into electricity by wind turbines which are connected to the power grid. This electricity is then transported to users through power lines or cables that distribute the electricity to homes and businesses.


What small piece of wire melts if it gets to hot due to electricity?

A FUSE Wire. It is made of a very soft low melting point metal. If too much Amperage (electricity) flows through the wire it heats up and melts the wire into a liquid, thereby breaking the electrical circuit.


What is the amperage of a t2l 250v fuse?

Darling, the amperage of a fuse isn't determined by its voltage rating. You need to check the markings on the fuse itself to find out its amperage. Don't go playing guessing games with electricity, honey. Stay safe and read the labels.


Why is 240 volt electricity more dangerous than 12 volt electricity?

It is neither more or less dangerous . The determining danger factor is amperage.


Why chemical always have to be dissolved in water in order to conduct electricity?

Chemicals do not always have to be dissolved in water to conduct electricity. Aluminum is 'purified' by electrolysis in the molted form. In the 1700's other metals were 'purified' by electrolysis as well with no water involved. Actually if water had been present it would not have allowed the chemical breakdown to occur to give a sample of ther free metal. Water solutions will conduct electricity of low voltage and amperage. The electrolysis mentioned above requires higher voltage and amperage ... much higher.