Darling, the amperage of a fuse isn't determined by its voltage rating. You need to check the markings on the fuse itself to find out its amperage. Don't go playing guessing games with electricity, honey. Stay safe and read the labels.
The current rating is 2A (2 amps).
No, it is not recommended to replace a 250V 3.15A fuse with a 250V 2.5A fuse. The replacement fuse should have the same voltage rating, but the amperage rating needs to be equal to or higher than the original fuse to ensure proper protection against overcurrent.
No, it is not safe to replace a 250V 10A fuse with a 125V 15A fuse. The voltage rating of the fuse must be equal to or greater than the system voltage, and the amperage rating must be equal to or lower than the rated current of the circuit. Using a lower voltage or higher amperage fuse can lead to safety hazards, including potential fire risks.
No
nope
The GMA series of fuse is a fast acting glass tube fuse. The dimensions are 5 X 20 mm. This series of fuse's amperage span is from 63 mA right up to 8 amps. I would suggest that your fuse is rated at 250 mA or (1/4 of an amp) with a 250 volt rating.
No, the amperage pin configurations are different between a 15 amp and a 30 amp plug.
yes it can but it may not protect as well the f5L is a fast blow fuse made to react quickly to the overcurent
T= timedelay 800= ? L=? 250V= volts
In most cases yes. but it depends on the application. The L in that model of fuse pertains to its ability to withstand destructive forces when it blows out.
Yes, you can use a 250V 3A fuse to replace a 250V 3.15A fuse, but it's important to consider the application. The 3A fuse will blow at a lower current than the 3.15A fuse, which may lead to nuisance blowing if the circuit regularly draws close to or slightly above 3A. Ensure that the device or circuit does not exceed the lower rating of the 3A fuse during normal operation to avoid interruptions.
Üretici: WickmannParça Numarası: F6.3H250VAmper: 6.3Voltaj: 250Malzeme: Seramik