T= timedelay
800= ?
L=?
250V= volts
The current rating is 2A (2 amps).
No
nope
Darling, the amperage of a fuse isn't determined by its voltage rating. You need to check the markings on the fuse itself to find out its amperage. Don't go playing guessing games with electricity, honey. Stay safe and read the labels.
No, it is not recommended to replace a 250V 3.15A fuse with a 250V 2.5A fuse. The replacement fuse should have the same voltage rating, but the amperage rating needs to be equal to or higher than the original fuse to ensure proper protection against overcurrent.
yes it can but it may not protect as well the f5L is a fast blow fuse made to react quickly to the overcurent
Divide the watts by the voltage to get current (amps). 60W / 250V = about 1/4 Amp.
In most cases yes. but it depends on the application. The L in that model of fuse pertains to its ability to withstand destructive forces when it blows out.
Yes, you can use a 250V 3A fuse to replace a 250V 3.15A fuse, but it's important to consider the application. The 3A fuse will blow at a lower current than the 3.15A fuse, which may lead to nuisance blowing if the circuit regularly draws close to or slightly above 3A. Ensure that the device or circuit does not exceed the lower rating of the 3A fuse during normal operation to avoid interruptions.
Üretici: WickmannParça Numarası: F6.3H250VAmper: 6.3Voltaj: 250Malzeme: Seramik
Depends on the voltage across the fuse. For fuses rated below 9 amps, the two types are almost identical (MDL has slightly lower AC Interrupting amperages), and both are rated for use up to 250V. For fuses rated above 9 amps, the MDL fuses are rated for use up to 32V, while the MDA fuses are rated for use up to 250V. More info on Cooper Bussmann (link below).
NO! The circuit wiring is protected by that 3.15 amp fuse. Put a 5 amp fuse in the circuit and the wiring may overheat and cause a fire. Never over-fuse any circuit even in an emergency.