answersLogoWhite

0


Want this question answered?

Be notified when an answer is posted

Add your answer:

Earn +20 pts
Q: Why is it blowing a fuse after changing the alternator coil on a 1990 Geo Tracker?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

Why will your engine shut off when you remove a battery terminal in your 1990 Geo Tracker?

That would indicate that the alternator is not functioning.


My air conditioner on my 1990 Honda accord was working fine then i changed my alternator and now its blowing out hot air why?

You probably inadvertantly unplugged the clutch connector for the A/C


Does the Geo Tracker have air bags?

does 1990 geo tracker have air bags


Where do you buy a fuel pump relay for a 1990 Geo Tracker?

Where can i buy a fuel pump relay for 1990 1.6 geo tracker


Rebuilding manual transmissions for 1990 Geo Tracker?

i want to know how to rebuild a manual transmission for a 1990 Geo Tracker 4x4


What is the firing order for a 1990 Geo Tracker?

Go to Google.com and type in the words "1990 Geo Tracker firing order" and it will get you to a site that will tell you.


Why would the amp light be on after changing the alternator battery and solenoid on a 1990 Ford Tempo?

I have the exact same pproblem with a 1988 tempo, replaced the alternator and battery, still the alternator only reads 5 volts when running. Can't figure it out, do you know of any websites that would have a diagram of the alternator for a tempo?


How do you replace the alternator on a 1990 Subaru Loyale?

Remove the wiring harness from your 1990 Subaru alternator. Remove the alternator belt. Remove the alternator retaining bolts. Reverse the process to install your new alternator.


Will a fivespeed trans out of a 1990 Geo Tracker fit a 1995 Geo Tracker?

Yes it should.


How do you replace an alternator on a 1990 Acura Legend?

Remove the belt from your 1990 Acura Legend alternator. Remove the wiring harness from the back of the alternator. Remove the alternator retaining bolts. Reverse the process to install the new alternator.


How do you change the alternator on a 1990 Buick LeSabre?

Loosen the tensioner bolt on your 1990 Buick LeSabre alternator. Slide the alternator to the left and remove the alternator belt. Remove the wiring harness from the alternator. Remove the alternator retaining bolts. Reverse the process to install the new alternator.


Where is your IAT sensor on your 1990 Geo Tracker?

The 1990 Geo Tracker IAT sensor is located on the top of the transmission. The IAT sensor will be near the back of the transmission.