Because the pins on the bottom of the processor can be easily bent (assuming that this is a processor for a PGA (Pin Grid Array) or SPGA (Staggerd PGA) socket. It is worth noting though that a processor for a LGA (Land Grid Array) socket is not as susceptible to this as the there are lands or pads on the bottom of the processor instead of pins; the pins are in the socket. The book that asks this question assumes PGA.
^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^
Very true BUT you can bend the lands in an LGA socket, rendering the socket hence the motherboard useless!
to protect the pins on the CPU
the pins will bend.
You don't want to bend the pins
You can bend (thus damaging) the pins on the underside of the processor
Because the pins or lands on the CPU or the CPU Socket are easily bent
Processor pins, or in modern computers the pins in the sockets, are very delicate and easy to bend. If you insert the processor any way other than straight down, you will bend the pins and likely destroy either the processor or the motherboard, or both.
So you don't break or bend the pins on the chip.
Sliding joints are those which allow small sliding movements between the bones, for example, the vertebrae of the backbone, allowing the back to bend. The wrist is a pivot joint. Wrist bones
It is a translation of the shape on the coordinated grid
bullet shooting from rifle,boy sliding in a slide,a plane flying straight,
It depends on what the motion is. If the square is sliding along a straight line then the path of the vertex is a straight line. If the square is rotating, the answer will vary according to the location of the centre of rotation.
If the sliding door on the 1999 Mercury Villager will not stay open, check for something that is not allowing the latching mechanism to lock into place. Make sure that the door is all the way back so that it can lock in.
I just shattered the rear sliding window of my Ford F250 and was told by Dave of Quality Glass in LaPorte IN that the current generation of rear sliding windows are designed so the glass cannot be removed to be replaced, so the answer given me was, I need to purchase a new sliding window assembly. I checked into replacing the sliding window with just straight glass and it actually cost me more than aftermarket sliding windows. This is not the definitive answer, but the working answer in my situation.
Similar but not the same. First rule: Don't panic, get skid under control. Second rule: Apply the first rule. Sliding on water is purely down to speed. The faster you go the less ability the tyres have to dispel the water. A cushion of water builds between the tyre and the road, traction is lost and aquaplaning (sliding) results. Don't brake, hold the wheel straight, take the foot off the gas and the car will come back under control very quickly. Sliding on ice can happen at any speed and black ice cannot be seen. Take the foot off the gas, reduce speed and do not brake, turn into the skid and gently accelerate until under control. Aim straight and (if no ABS) quickly pump the brakes until the vehicle stops. If ABS, aim straight and brake normally.