Want this question answered?
Wear Safety Goggles Do NOT Touch The Element If The Flame Goes Out Turn Off The Gas Immediately
how to be safe using a Bunsen Burner:1. never leave the flame unattended... especially when on the blue flame.2. always wear safety glasses.3. don't heat up anything metal because they will get very hot.4. don't let young children near the Bunsen burner when it's on.5. always have someone watch it.6. turn the gas off immediately when the flame goes out.
to get a life man who every goes around
because sometimes scientist can can create them but the experiment goes wrong so it's important to recreated so they can fix their mistake
It does that because you have memory loss. Your mind just goes blAnk!
The Bunsen burner goes under a thin, fireproof chemistry table.
A wire gauze is placed on a tripod stand on top of a Bunsen burner.
Wear Safety Goggles Do NOT Touch The Element If The Flame Goes Out Turn Off The Gas Immediately
Goes to the oxygen.
Wear Safety Goggles Do NOT Touch The Element If The Flame Goes Out Turn Off The Gas Immediately
Little/none
Once the temperature goes over 0`C. (Bunsen burner)
If you turn off the gas, there is no fuel for the fire, so it goes out.
how to be safe using a Bunsen Burner:1. never leave the flame unattended... especially when on the blue flame.2. always wear safety glasses.3. don't heat up anything metal because they will get very hot.4. don't let young children near the Bunsen burner when it's on.5. always have someone watch it.6. turn the gas off immediately when the flame goes out.
When you reduce the gas, the flame goes down because you are starving the flame. Slowly turning off the gas is the correct way to put out a Bunsen burner. Never blow it out or gas will collect in the room.
A wing tip in chemistry is a part for the Bunsen burner. It is a piece that goes on top and can help spread the flame wider.
Funtions of the Bunsen burner: air-hole: to control the amount of air let into the Bunsen burner for combustion. barrel: To allow the flame to beat a suitable height for burning. base: To support the Bunsen burner so that it will not fall over. collar: helps to adjust the gas being produced gas tap: to store gas. jet: To allow gas to enter the Bunsen Burner ( by helpingppl) Flame: the one part you don't want to forget