This part is called several other names. 1) A camshaft position sensor. 2) Stator 3) Sync-Pulse Generator. 4) Auto Zone had it but called it a Pick-Up Coil (Part Number CR149).
The camshaft position sensor is inside the distributor. The crankshaft position sensor is in the top of the bell housing on the driver side.
On the top of the bell housing. thats the crank position sensor the cam sensor in a 93 is fixed in the distributor to replace it you need a new distributor
I6 in the distributor V8 under the front of the passenger side cylinder head.
The Camshaft sensor is located in the distributor.
It's located on the distributor. You don't have to remove the distributor to replace the sensor. Remove the air cleaner, disconnect the negative battery cable, remove the distributor cap, disconnect the camshaft position sensor wiring harness, remove the distributor rotor, lift the camshaft position sensor assembly from the distributor housing Camshaft Position Sensor. Installation, Install the camshaft position sensor into the distributor. Align the sensor into the notch on the distributor housing, connect the wiring harness, reinstall the rotor, reinstall the distributor cap. Tighten the mounting screws, reinstall the air cleaner.
Camshaft position is taken from the distributor, there is no separate sensor.
The camshaft position sensor on a 4.3L engine would be in the distributor.
Inside the distributor.Inside the distributor.
It is also known as a Pickup Coil that is located under the rotor inside the Distributor cap.
Yes, it is inside the distributor.
The Dodge Durango was introduced in 1998, so this question cannot be answered. However, in the 2000 Durango.... The camshaft position sensor is located in the distributor on all 3.9L V-6 and 5.2/5.9L V-8 engines Camshaft Position Sensor REMOVAL Distributor removal is not necessary to remove camshaft position sensor Remove air cleaner assembly. Disconnect negative cable from battery. Remove distributor cap from distributor (two screws) Disconnect camshaft position sensor wiring harness from main engine wiring harness. Remove distributor rotor from distributor shaft. Lift the camshaft position sensor assembly from the distributor housing Camshaft Position Sensor INSTALLATION Install camshaft position sensor to distributor. Align sensor into notch on distributor housing. Connect wiring harness. Install rotor. Install distributor cap. Tighten mounting screws. Install air cleaner assembly. (this info from post on answers.com about cps on 2000 durango)
located in the distributor