Why is it required a clean wire loop in order to observe a spectrum?

Answer 1

Classic Wire Loop Method

First, you need a clean wire loop. Platinum or nickel-chromium loops are most common. They may be cleaned by dipping in hydrochloric or nitric acid, followed by rinsing with distilled or deionized water. Test the cleanliness of the loop by inserting it into a gas flame. If a burst of color is produced, the loop is not sufficiently clean. The loop must be cleaned between tests.

The clean loop is dipped in either a powder or solution of an ionic (metal) salt. The loop with sample is placed in the clear or blue part of the flame and the resulting color is observed.

Wooden Splint or Cotton Swab Method

Wooden splints or cotton swabs offer an inexpensive alternative to wire loops. To use wooden splints, soak them overnight in distilled water. Pour out the water and rinse the splints with clean water, being careful to avoid contaminating the water with sodium (as from sweat on your hands). Take a damp splint or cotton swab that has been moistened in water, dip it in the sample to be tested, and wave the splint or swab through the flame. Do not hold the sample in the flame as this would cause the splint or swab to ignite. Use a new splint or swab for each test.