answersLogoWhite

0


Best Answer

Modern cars you cannot because manufactures think its not safe, by depressing the clutch you can make extra sure it will not sudden launch forward. But with older cars there is nothing stopping you from starting the car in neutral, you can even start it in gear but it most likely move a little forward than stall.

User Avatar

Wiki User

11y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: Why is it that you have to step on the clutch before you can start the engine?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

Does a manual transmission have a neutral switch?

Most use a "clutch" safety switch, usually located at the upper end of the clutch pedal. You must step on the clutch before the vehicle will start


Why won't my truck 1995 Nissan XE start I press on the clutch- the electrical systems go on but no engine starting Same as if I don't step on the clutch Help?

Could be a bad starter or starter solenoid


Is it ok to step on the gas to start a car engine?

Not unless it is a carburated engine.


When i drive my Ford Fiesta flair and step on the clutch the revs keeps climbing. What do i do?

Just start it like normal and when the revs start to sound distorted start accelerating


What step are usually undertaken before the start of an IT project?

t6yy


Can you have step by step instructions on how to change the clutch on your mk3 golf 1.8?

Yes


How do you adjust an ogura electric clutch?

step by step guide is listed in link below


How do you bleed a clutch in a Vauxhall vivaro?

See the related links for step by step instructions.


How do you replace a clutch on a Yamaha blaster step by step?

Buy a yamaha blaster manual. Shows you step by step picture by picture.


Your clutch makes a funny noise when you step on it How do you fix it?

When your clutch makes a funny noise when you step on it, you might simply have sand in the mechanism. You can begin by cleaning the clutch. If this does not help, check the clutch slave cylinder to see if it is working properly as it tends to cause a squeaking sound when it is damaged.


What would cause an engine to make a loud knocking sound once every 3 seconds while in park or neutral?

The failure to step on the brake pedal or if manual the failure to step on the clutch The transmission or gearbox is not working properly


How do you do a burnout in a manual?

Step 1: Rev Engine. Try not to rev too high, or you may cause damage. Step 2: Dump the clutch. This is achieved by quickly depressing the clutch pedal. Step 3: Try not to die. Because you have to ask how to do a burnout you probably lack the technique to perform the simplest of driving tasks. Actually, you should probably just stop driving all together.