0
Why is my Winchester 1400 not ejecting fired shells the piston has been replaced and the gun cleaned thoroughly Any suggestions?
Wiki User
∙ 12y ago
Type your answer here... For some reason this winchester shotgun does not like the winchester target load shells. Try another type of shell or one a little more powerful and you will not have any problems. Great gun just a little temperamental. I own 2.
Wiki User
∙ 12y ago
Add your answer:
Earn +20 pts
What is the value of a prewar .30-06 Winchester Target Rifle - Bull gun with a barrel replaced by Winchester in the early 1960's?
Requires professional appraisal.
What year was this gun manufactured Winchester Model 1400 auto 12 GA serial No 199612?
The Winchester Model 1400 was manufactured in 1964. This was one type of gun that replaced earlier Winchester models. Winchester Repeating Arms Company was founded in 1866.
Who replaced Frank Burns on the TV show MASH?
Major Charles Emerson Winchester III, played by Davis Ogden Stiers. Whilst initially an enemy of Hawkeye and BJ, as was Frank Burns, eventually Winchester reached a sort of truce and almost mutual respect with Hawkeye and BJ.
Your 89 Bronco dies like its out of gas soon after its warmed up you have replaced the fuel filter and coil with no change any suggestions?
fuel pump or the ignition module needs to be replaced
There is no spark to a 1997 for E150 van it will not start replaced coil any suggestions?
Check to see if your vehicle jumped timing.
Replaced fuel pump on 1991 camaro rs it worked for 3 days then quit suggestions?
It could be defective...hope you got a warranty
2004 Monte Carlo overheats radiator replaced cooling sensor replaced cooling system flushed fans replaced thermostat replaced any suggestions on fixing problem?
you might want to check for a blown head gasket or a cracked head or block. espically if it loosing water out of the radiator with out leaking on the ground.
You have got a 69a which fails to fire repeatedly replaced the firing pin and spring to no avail any suggestions to remedy the problem?
It needs the attention of a gunsmith.
You have a 2000 Malibu with a 3.1 The lifters have been replaced but there is still a ticking from the engine any suggestions?
a lot of 3.1 engines do this, if it is not severe then it should be ok...
You replaced all brake parts on your 1996 Pontiac sunfire and your brakes still do not work any suggestions?
bleed the brakes. check fluid level
93 probe gt replaced mass airflow sensor car turning over not starting replaced distributor and wires - any suggestions plan to pull codes this evening?
Check condition of ignition coil. Replace if bad.
What year Winchester Model 88 serial number 158202A made?
1964 The "A" suffix usually means it was a replaced receiver or a duplicate number.
