You have the gains set too high on the amp.
I ran it with that amp and it started clipping, so lower the settings on amp, the amp is a monster!!!
you overdrive it by clipping it, by having the input signal being to strong. anything above -0db on the amp is clipping, so be careful.
Clipping on an amp can be caused by many different things the most common problem is that the amp is being over driven try decreasing the input voltage, and sometimes its the part value inside the amp try changing capacitors or resistors but only if you know how to do so if you are not trained don't attempt this or you may destroy your amp ANSWER: Clipping is really caused by over driving an amplifier to both B+and/or B- saturation BY EXCESSIVE INPUTS
Clipping occurs in the voltage waveform when the input voltage, multiplied by the voltage gain of the op-amp circuit, exceeds the op-amp supply voltage as limited by the output network. The supply voltage and output network, limits the maximum voltage that can be achieved at the output. The op-amp behaves normally within its range of maximum voltage output, and then it is clipped when it reaches the maximum voltage of the circuit.
you dont
The car stereo amp on a 1994 Lincoln town car Is in the trunk, right side behind the seat
In April 2008 Dale Jr drove the Amp Energy car. In October 2008 he will also drive the Amp Energy car- however it will have a special paint scheme in which 70,000 fan names will be on the car.
The dimensions of a car amp vary depending on the supplier of the amp and model of the car. Typical dimensions are around 2.25" x 9.88" x 20.25" though they can be found both bigger and smaller.
. Interior and exterior clipping interior clipping what is to be saved is inside the clip window exterior clipping what is to be saved is outside clip window Interior clipping
i am clipping my nails
The amp will lead a dull and empty life.
something is wired up wrong or you overloaded the amp