incorrect gearbox oil. There is a lot of talk about the correct oil to use, even some Ford garages use the specified oil(which is incorrect). Some Ford garages do use a different oil. If you check out honestjohn website or Mondeo owners club sites they will tell you the correct/best oil to use in the gearbox.
Rory
The Ford Mondeo ST220 could be jumping from 2nd gear due to a chipped gear or worn shifter fork. The transmission will probably need to be taken apart to be repaired.
First, unscrew the gear knob and lift the trim from the back. Then, lift the gaiter and the trim away from the console plate. Next, remove the old gaiter from the trim. Finally, line up and connect the new gaiter to the trim and reconnect the trim to the console plate.
You can find plate armer by going to the gear merchent at the frount of bowerstone south you just can't buy dark or bright plate from him :)
on a v6 mondeo st24 the spped sensor is on the right hand side of the gear box access is gained frm under the car on a v6 mondeo st24 the spped sensor is on the right hand side of the gear box access is gained frm under the car
The Knob is threaded , Just unscrew it by hand
Simply, you wear Heat Gear when it is hot, and Cold Gear when it is cold. Heat gear is made of a thinner material, and is generally cheaper than Cold Gear.
if its cold out your gear oil is just very thick which makes it hard to shift once the car gets going it should be fine
For running gear in cold weather I would suggest going to Dicks Sporting Goods if your willing to pay a little more. If not I would suggest Amazon where you can get great quality at a little cheaper price.
will a gear shifter fork plate on 89 ford f150 work on 96 ford f150
Are you letting the car warm up before putting it into gear? because you should, especially in cold weather.
On the gear-lever. Just pull it up before shifting it into gear. My girlfriend woke me up because of the same reason. Who drives a car without knowing how to reverse it?? :-D
The gear shift lamp on a 2006 Toyota Corolla can be replaced by taking apart the gear shift plate and replacing the bulb. This can be a very complicated procedure. The top of the gear shift plate is held on by clips at the front and back.