The entire 1N40xx series of power diodes are all silicon. The OA79 small signal diode is germanium.
It is used for the radio control of model aircraft,boats, cars.
Synchronous demodulation is done using the same modulating signals such as cos(2000t) that was used in the transmitter. It still has to use Band-Pass (if multiple signals are present) and Low-Pass filter
demodulation
Demodulation takes place to extract the low-frequency signal from the high-frequency carrier, using a nonlinear process that produces components at the signal frequency. The LP filter is used to eliminate the high-frequency carrier component from the signal so that it does not cause problems at a later stage in the amplification of the signal.
In case of coherent demodulation carrier used for demodulation purpose is in phase and frequency synchronism with carrier used for modulation purpose. For non-coherent demodulation it is not in synchronism.
In general O in diodes stands for germanium.since OA79 is a germanium diode O stands for germanium
The only difference is the maximum repetitive capability which is maximum for IN4007 compared to OA79
The entire 1N40xx series of power diodes are all silicon. The OA79 small signal diode is germanium.
In OA79, the letter A stands for rectifier diode and O stands for Germanium. It acts as a point contact germanium diode and also be replaced with 1N4148 depending on the circuit.
oa79 is frequency diode... it pass only the bit of frequency..
Carrier signals that carry information by the process of frequency- or phase-modulation.
It is used for the radio control of model aircraft,boats, cars.
Synchronous demodulation is done using the same modulating signals such as cos(2000t) that was used in the transmitter. It still has to use Band-Pass (if multiple signals are present) and Low-Pass filter
The word "modem" comes from the contracting of the two wordsmodulator, and demodulator.MOdulation DEModulation
demodulation or detection.
modulation and demodulation