Want this question answered?
Float height settings for the Kawasaki bayou are 17 millimeters from the edge of the float bowl to the very top of the float. Raising the float lowers the fuel level, this will also prevent fuel from coming out of the overflow tube.
not a bayou but my ninja 250 over flow tube was leaking and i replaced te two o-rings on either side due to cracks and no more leaks. i had to get them from the dealer because i couldn't find them at a parts store. they were like 4.00 each but had to have them. the o-rings for the fuel rail i found at Orileys though.
On a 2004 Ford Expedition , 4x4 : The front differential has a tube ( hose ) coming off the top of the differential ( the biggest part of the case where the gears are )
Tube - 2004 was released on: USA: 22 February 2004 (Instant Film Festival) Thailand: 30 September 2004
Where is the ac drain tube for 2004 grand prix
The drain hose is located to the left of the engine compartment just below the AC lines coming out of the firewall. There is a rubber tube about 1" diameter and it has a small plastic tube coming out from the bottom side of the larger tube. This sometimes gets blocked and causes leaking onto the rug area inside the truck, just pull the larger tube out and clean the small/large tube. If there is any water from the AC it will drain out. MrT.
Because the tube (hose) is defective and needs to be replaced. That tube is coming directly from the fuel filter being pumped by the fuel pump to the carburetor. Replace the tube/hose or you WILL have a major engine fire and/or huge KABOOM.
On a Kawasaki Ninja, the crankcase breather hose hooked o the air box. Because oil vapor is drawn through the tube, there will be a small amount of oil in the air box.
Breather tube to allow gasses to escape from the battery
This is gaseous water.
call 911 and pray...
It is located on the tube of the intake. As soon as you open the hood of the truck you'll see the tube leading to a box on the right right side of the engine bay. The sensor is the wire harness coming out of the tube after the ribbed part of the tube. Hope this helps. The air intake temperature sensor is built into the MAF itself on the Titan