0
Why is seat belt warning lamp switched on at all time in Passat 98?
Wiki User
∙ 14y ago
theres wiring goin to it, the wiring could be undone, otherwise you may need completely new wiring. hope this helped : )
Wiki User
∙ 14y ago
Add your answer:
Earn +20 pts
How do you disable the seatbelt alarm in a 2002 Ford Crown Victoria?
Belt Minder Deactivating/Activating Preparation Before deactivating/activating the belt minder, set the parking brake. Place gearshift in P (Park) (automatic transmission) or the neutral position (manual transmission). Place the ignition switch in the OFF position. Close all the vehicle doors. Unbuckle the driver's safety belt. Place the parklamps/headlamps switch in the OFF position. (If vehicle is equipped with Autolamps, this will not affect the procedure.) Deactivating/Activating Turn the ignition switch to the RUN position. (Do not start the engine.) Wait until the safety belt warning lamp turns off (approximately one to two minutes). NOTE: Steps 3 through 5 must be completed within 60 seconds or the procedure must be repeated. Buckle then unbuckle the safety belt three times, ending with the safety belt unbuckled. This portion of the procedure can be done before or during belt minder warning activation. Turn the parklamps/headlamps on then off. Buckle then unbuckle the safety belt three times ending with the safety belt unbuckled. After this step the safety belt warning lamp will be illuminated for three seconds. Within seven seconds of the safety belt warning lamp turning off, buckle then unbuckle the safety belt. This will enable the belt minder if disabled or disable belt minder is enabled. The following sequence of events confirm the belt minder is enabled: flashing of the safety belt warning belt lamp four times per second for three seconds three seconds with the safety belt lamp off flashing the safety belt lamp four times per second for three seconds again The safety belt lamp flashing four times per second for three seconds provides confirmation of belt minder disabled. After confirmation, the deactivation/activation procedure is complete.
How do you get rid of replace lamp warning on Panasonic tv after lamp replacement?
The lamp must be adjusted.
How do you reset Toyota land cruiser year 2000 timing belt warning light?
According to the repair manual: Remove the grommet from the speedometer and turn off the lamp by pushing the warning light reset switch, then replace the grommet.
What does exhaust gas warning lamp mean ona2003 polo?
why does the exhaust gas warning lamp symbol come up on the dash board
When lamp is switched why it shine?
because you can't see they don't shine
Plug a lamp into an electrical socket and you turn electrical energy into this form of energy?
-- None at all if the lamp is switched off.-- If the lamp is switched on, then electrical energy is turned into a little bit ofvisible light energy and a comparatively larger quantity of heat energy.
Turn signal intermittent on 2002 VW Passat?
Bad Lamp on that side. Change all bulbs.
What does the yellow round light with 3 dashes represent on a VW Passat?
Front brake pad warning lamp. If this come on while driving, it is time to check your front disk brakes pads for wear - probably a good time to check the rear pads, too.
Reset warning light for 2006 BMW 750Li?
Depends on the warning lamp. Consult your local dealer.
What does the gas warning lamp mean on vw polo?
i dont no
How do you reset the timing belt light on a 93 4.2 landcruiser?
According to the repair manual: Remove the grommet from the speedometer and turn off the lamp by pushing the warning light reset switch, then replace the grommet.
How do you turn off the timing belt light on a land cruiser 1999?
According to the repair manual: Remove the grommet from the speedometer and turn off the lamp by pushing the warning light reset switch, then replace the grommet.
