0
Too many variables for that symptom, could be a fuel system problem, timing, or ignition problem. Make sure timing is correct, check your spark plugs, cap, rotor, and wires. While you are checking your plugs, check your compression. If all that checks out, look to your fuel system. If your vaporizer needs to be rebuilt or replaced it can cause you a lot of problems. Yale/Hyster FE & F2's usually tend to start pretty quickly and easily. Hope that helps.
Wiki User
∙ 12y ago
Add your answer:
Earn +20 pts
Cold Weather Hard start Mazda?
My 1999 Mazda 626 is hard to start any time but then we kick start it then it start fine and dies at any robot will I'm driving My 1999 Mazda 626 is hard to start any time but then we kick start it then it start fine and dies at any robot will I'm driving
Mercedes sprinter diesel engine hard to start when cold?
Most diesel engines are hard to start when it is cold. Plugging the diesel engine block heater in will help the engine start.
Is it hard to change a water seal on a Mazda rx7?
Yes. You must take the engine apart.
Is a forklift driver required to wear a hard hat?
A forklift drive is not required to wear a hard hat. Wearing a hard hat is suggested for your safety though.
How do you know when a crank sensor is bad in a 1988 Mazda 626 and how do you replace it?
Generally when the crank sensor goes out the engine will not start. The sensor on almost all vehicles is located in the front on the engine near the belts.In most cases it is held in place by a bolt.Usually they can be hard to get to.
Why is it hard for a car to start when the engine is cold?
It is not so much hard for a car to start when the engine is cold as it is easier for a car to start when the engine is warm.Cars that are hard to start in the cold are usually not new cars any more and because of wear and tear there is more likely to be something that doesnt work as well. when fuel is warm it ignites more easily.
Do you need to wear a hard hat whilst on a forklift in a hard hat area?
Obviously
What does stale gas do to an engine?
Makes it hard to start and run poorly.
What are the reasons a 1994 Mazda B-3000 pickup will not start after being driven?
AnswerPer Mazda troubleshooting guide for "Engine hard to start when hot": (1)air filter clogged; (2)fault in the fuel or electrical stsems; (3)fuel not reaching the injectors. Replace ECM relay Mazda part # BTDA-67-740 relay coolant fan $12.00 part. Had too get diagnostic at dealer to find problem solution. It does not seem connected to problem but it is.
What are the reasons a 1994 Mazda B 3000 pickup will not start after being driven?
AnswerPer Mazda troubleshooting guide for "Engine hard to start when hot": (1)air filter clogged; (2)fault in the fuel or electrical stsems; (3)fuel not reaching the injectors. Replace ECM relay Mazda part # BTDA-67-740 relay coolant fan $12.00 part. Had too get diagnostic at dealer to find problem solution. It does not seem connected to problem but it is.
1993 Mazda 626 is hard to start when its cold?
maybe weak battery or an injector component is defective ( the additional injector that gives extra fuel to start the car )
How can you tell when the egi fuse is bad on a 1988 Mazda rx7?
car will have a hard time starting, or more commonly will not start at all
