Want this question answered?
The narrower the bore the less liquid (mercury or alcohol) is required so the bulb containing the fluid will adjust more quickly to the temperature being measured. o.k well the narrower bore makes the liquid move slower up the thermometer so the accuracy is better ?????
If it is a 1.5 volt bulb you can connect it through a series circuit directly to your battery. If the bulb is not made to run on 1.5 volts and needs another voltage, it may not light up!
the higher the wattage is the hotter it gets
WORKING: Place the bulb of the thermometer filled with mercury in a vessel ov small pieces of ice the mercury will arise in the tube and will come to rest at a certain point.this point shows the melting point of ice. CONSTRUCTION:A thermometer consists of a glass bulb filled with mercury.A cappilary tube arises from this bulb.Due to the narrow bore of the tube a small change in the volume of the mercury becomes significiantly visible.
A bulb does not light up if there is no voltage available across the bulb, or if the bulb is burned out.
The narrower the bore the less liquid (mercury or alcohol) is required so the bulb containing the fluid will adjust more quickly to the temperature being measured. o.k well the narrower bore makes the liquid move slower up the thermometer so the accuracy is better ?????
Look at my answer for the question posted directly above this one.
No. A light bulb is a directly-heated monode.
Remove the headlight directly above the fog light,you can reach down easily to access the lamp
It is called a socket or base. This keeps the bulb securely in place and allows electricity to flow directly to the bulb.
First you open the hood, the left or right side, its the same, directly above the light in question you must remove or open a panel or cover to gain access the back of the assembly in which you will figure out if it is a high-beam or not and then twist the bulb and the connection counter clockwise and you should be able to free the bulb. once the bulb is free disconnect the connection and insert the new bulb and revese instructions!
Pop the hood. Now look down at the turn signal lense from directly above the lense. You will see two screws that are holding the lense in place. Remove those screws and then just pull on the lense. Once out change the bulb with a 2057NA bulb then reassemble.
which bulb??were is it located?? ceiling dome above driver
In a 2003 Ion Sedan, you...: * Pop the hood * Above each headlight are 2 L shaped pins. Turn, and then pull them directly up to remove them. * Pull the headlight housing straight out. * Turn the bulb housing for the blinker to unlock it and remove the bulb.
You should not use a bulb above 100watts.
A bulb is said to be fused if the filament gets broken . Fused bulb doesn't glow. The two terminals do not directly touch each other to avoid short circuit.
The brightness of a light bulb directly has no direct relationship with magnets and wire. The bulbs brightness is determined by the wattage of the bulb. The higher the wattage of the bulb the brighter the bulbs light output.